0
Locking Mechanism controlled by your brake pedal has failed.
It will need to be repaired
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How do you put a 2001 Mazda millenia in neutral with a dead battery?
On the shift console of an automatic Mazda millenia there is a small plastic cover to a hole near the gear shift lever. If you pull the tab off you can stick a screw driver (slim) into the hole and release the shift into neutral - any tow truck operator can show you how incase you have trouble.
Shift lever will not lock into a gear?
700r4 gear shift lever want lock in place
How do I replace the Shift handle on a 1986 Chevy Celebrity?
Are you asking about the shift lever on a column shift car or the console shift handle?
Why shift lever does not work?
The shift level is locked by the shift solenoid. When you step on the brake, the brake switch sends power to the shift solenoid and it moves a lever to unlock the shifter. If either the switch or solenoid is bad, you can't shift out of park.
Bushings on shift lever of a 1988 Mazda rx7?
Take apart your shifter console and all the rubber boots under, you will see them.
Where is transmission shift solenoid located on a 2000 Mazda protege?
where is the transmission shift solenoid located on a 2001 Mazda protege
You have a 1992 Mazda Protege hold light remains on?
I suspect your hold switch on the shift lever might be bad..or ahs a broken wire.
How do you shift a 1984 Honda TRX 200 into reverse?
shift to nutral,then move lever to reverse
Gear shift lever button will not engage to move the gear shift lever out of park 2006 dodge stratus?
check the brake pedal switch
How would you go about fixing a gear shift lever on a 2001 Buell blast after you put it in 1st gear it fell down like a spring broke off in the primary maybe any help would be appreciated?
I have had the same problem with my 2002 Buell Blast, where when you shift to first, or down shift at all, the shift lever comes loose and just hangs. What I did to fix this, is loosen the hex-nut and bolt that go through the shift lever, and remove the shift lever itself. What is probably happening is oil is seeping in between the shift lever openining and the primary. Clean the openinig on the shift lever, and the spool it attaches to. If the hex-bolt is in poor condition, pick up a new one, or if it's in alright condition (not stripped) clean it. Simply set the shift lever where you want it, and retighten the hex-bolt. Tighten it a fair bit, using a lever to get extra leverage on it. Buells are notorious for leaking oil, so start with that. Worked for me...
What to do with a loose shift lever on a 1992 Yamaha yz250?
same problem:( cant even shift though..
Where is the overdrive button on a 98 Ford Taurus located?
On a 1998 Ford Taurus ; On the column shift the overdrive button is on the end of the gear shift lever On the console shift the overdrive button is on the drivers side of the gear selector lever below the button you have to press to shift out of PARK
