polaris 250 wont start
what year is my polaris 250 trailblazer ? vin number is 4xaba25c4y2453002
my 1998 Polaris Trailblazer has about 26hp and i have got it up to about 60mph
A picture of the clutch assembly removal process for a 250 Polaris Trailblazer can be found in the repair manual. It details how to access, disassemble, and remove the assembly.
When you find out let me know,, i have a 2001 250 trailblazer doing the samething..someone told me it might be compresion also..do you know what the compresion should be ?? Richard Fisher rfisher1169@gmail.com if i find out anything i will let you know as well
your compression should be around 125-135 psi. for a 250cc polaris trailboss or trailblazer.
Ngk br8es
i would leave it alone.
well mine was doing it and finally the chan inside trnsmission broke
how do you tighten the chain on a 1999 polaris trailblazer 250 if the brake assy. is on the rear end then u need to loosen the 2 - 1/2 bolts on the bottom of the brake assy. and the to 5/8 bolts on the rear end then turn the part between the 2 5/8 bolt with a pipe wrench.
I have a 1993 Polaris 250 Trail Boss. It won't start. It floods out the carb. Could it be low compression?
There are two ways to start a 98 Trailblazer. One way that you can is if you have a battery in your atv and the starter doesnt need to be replaced, you turn on the key then make sure the run switch is on and then press and hold the starter button on the left side of the handle bar or if your starter is out like on mine, you will have to use the pul start on the right side of the atv and if you have the airfilter on and have gas and oil in it, it will start with one pull.
Turn the fuel/air screw all the way in. Then back out about 1/4 turn. That should get you close. May have to tweek alittle in or out.