0
Why are most homes wired in a parallel circuit rathen than a series circuit?
Wiki User
∙ 13y ago
Series circuits , the voltage is drawn by instruments progressively from source to end whereas parallel circuits give a constant voltage through all the points connected parallel to the source hence the name.In series circuit,the more the power drawn by an instrument,the lesser the voltage available for the next instrument connected after it serially from the source. Hope this solves the question
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
What does a parallel circuit do?
A parallel circuit has more than one resistor (anything that uses electricity to do work) and gets its name from having multiple (parallel) paths to move along . Charges can move through any of several paths. If one of the items in the circuit is broken then no charge will move through that path, but other paths will continue to have charges flow through them. Parallel circuits are found in most household electrical wiring. This is done so that lights don't stop working just because you turned your TV off.
What is the place in the home that contains the circuit breakers?
The ciruit breaker box. This is usually mounted near the main power source in the home. Try the basement, the back porch, or near the kitchen. If all else fails, go outside and look where the power meter is. The breaker box should be nearby inside the home. In many homes the electrical panel is in the basement. In homes that do not have basements the electrical panel is placed in the garage.
How are lights wired in a house?
"House wiring" is a category of wiring which refers to wiring within the confines of an immobile dwelling house, apartment, etc. It does not refer to mobile homes, caravans, canal barges or any other kinds of mobile dwelling.Someone could spend a week typing to "tell you about house wiring". Go to a hardware store like Home Depot, buy a book on home wiring and read it!No, its not too hard to describe: in USA, Canada and other countries which use the same standard alternating current service - which runs at 60 cycles per second - it comes to the outlets using black and red hot wires, a white neutral wire and a bare ground wire.Each circuit is built to provide electric power for a particular use: for lights, for small appliances - such as camera or shaver chargers, radio and tv, toaster, etc. - or for large appliances such as freezer, cooker, washer, dryer, water heater, air conditioner, etc.The maximum current supplied in each circuit is limited to the capacity of its circuit breaker, which depends on the thickness of the wires used.In turn, the wire thickness used to build a circuit - and the voltage it supplies - depend on the uses for which the circuit is intended. A rough guide is: the bigger and heavier the appliances are, the more voltage and current they require. In a normal size home, the sizes of its circuit breakers start at around 15 amps and go up to 100 or 200 amps for the main incoming service line wiring.If there are three wires in a circuit - colored "black, white and bare" or "red, white and bare", that circuit is for 110 to 120 volts to be used for lights and small appliances.If a circuit has all four wires: "red and black and white and bare", that circuit supplies 220 to 240 volts for a cooker, a washer, a dryer, a water heater, etc.Everything that is installed as house wiring must comply with the NEC (National Electrical Code) and any further requirements of the locality. (Town, city, state, etc.) For example, in New York City the wiring codes - which are part of the city's Building Codes - do not allow new home circuits to be installed by anyone who is not a licensed electrician.Many other places in North America allow home owners to apply for a Home Owner Permit, but any DIY work done must still comply with the requirements of the NEC. Such DIY work is often checked by the safety authorities for compliance with the NEC before they will allow it to be connected to the incoming service at the main breaker panel.As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.Before you do any work yourself,on electrical circuits, equipment or appliances,always use a test meter to ensure the circuit is, in fact, de-energized.IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.
Why dc series motors cannot be used in home?
DC series motors run on DC power. Homes have AC power, not DC power. You could use DC motors in homes if you have a power supply or use a battery, but it is usually more cost effective to use an AC motor.
What type of circuit breaker is required for a 240 v branch circuit?
the circuit breaker used will be miniature circuit breaker(MCB) maily used in homes.Answer for USA, Canada and countries running a 60 Hertz supply service.A two pole circuit breaker is used for a load of 240 volts. It is sized, according to the load amps of the device, to protect the wires that supply the load current.
How many paths does a parallel circuit have?
a parallel circuit has 2 or more paths.a series circuit has 1 path.a parallel circuit is better for homes and school
Are homes on a series circuit?
No. Plugs, lamps and 220 V a.c. items are in parallel with the breakers.CorrectionAll loads are in parallel with the supply voltage, but in series with the circuit breakers or fuses.
Why are most homes wired in parallel circuit rather than a series circuit?
Most homes (probably all homes) are wired in a parallel circuit (actually several parallel circuits and a few dedicated circuits) so that in the event of the failure of one device in the circuit, the rest will continue to function.
Why are most home wired in a parallel circuit rather than a series circuit?
Most homes (probably all homes) are wired in a parallel circuit (actually several parallel circuits and a few dedicated circuits) so that in the event of the failure of one device in the circuit, the rest will continue to function.
Do modern homes use electricity that is arranged in series or in parallel circuits?
In a modern home you use parallel circuit's. The reason why they are parallel circuit and not series is For example: say your kitchen light goes off, if that light goes off the others in your house won't. They also use parallel circuit in schools. However, when there is a switch in the circuit, that switch is in series with the load, so you could say that electrical wiring is arranged in series-parallel.
How is the wiring done in houses and or other occupied buildings?
It is in parallel, so one light can be on while others are turned off.
Are the circuits at homes connected in series or parallel and why?
They're connected in parallel, this is so that everything connected to the circuits will receive the same voltage. Also, if everything was connected in series, if one of the components died, everything would be dead (think of christmas lights)
What type of circuits are used in most homes-parallel-or-series?
parallel
What kind of circuit is most common in your homes?
The most common circuit is the parallel circuit. If you notice, on a chandelier, if one goes out the rest stay on. If you would have a series circuit then your house lights would be very dim because of all the usage of lights.
Is the electric circuit in your home a series circuit or parallel circuit?
In my home, all of the utility outlets and all of the AC electrical devices we use arein parallel with all the others, and also with all similar outlets and devices in all ofthe homes of all of our neighbors whose houses are on the same transformer.
Why is it not practical to use series connection in your homes?
in a series circuit, if any one item is turned off or unplugged, the entire circuit fails.
Which type of Electrical wiring is used in your homes and offices?
Parallel for main circuits and series parallel for lighting circuits.
