Gravity draws a bullet toward the ground, more so the farther the distance so a proper sight alignment for 50yds will need to be changed for 100yds to compensate for loss of velocity and gravity. In other words the farther away a target is the higher above the target you will need to aim and if you want the sights to be on the target when aiming they must be adjusted. This adjustment is called " elevation " and " Windage " is the name for the compensation for side to side adjustment to air currents.
Gravity draws a bullet toward the ground, more so the farther the distance so a proper sight alignment for 50yds will need to be changed for 100yds to compensate for loss of velocity and gravity. In other words the farther away a target is the higher above the target you will need to aim and if you want the sights to be on the target when aiming they must be adjusted. This adjustment is called " elevation " and " Windage " is the name for the compensation for side to side adjustment to air currents.
Fixed sights, adjustable sights, target sight, night sights, 3 dot sights, telescopic sights, red dot sighs, lasers, etc.
To pinpoint the target.
You are focusing on the sights and not the target.
In this forum's context, Smith and Wesson, Target Sights.
Sights are typically metallic, either a V notch at the rear, and a post at the front, or a peep sight (small hole in metal disk) at rear, post at front. A scope (short for telescope) is mounted to the rifle, and has a set of cross hairs that can be adjusted up/down and left/right. It has the effect of bringing the target closer. You adjust cross hairs so they are crossing where the bullet strikes. However, simple metal sights may be preferred to a scope in certain conditions- low light, snap shooting, etc. There ARE other sights, such as the "red dot" sight- they superimpose a dot on the image of your target (only in your view- not really on the target) Unlike a scope, most do not magnify the target image.
Most aftermarket sights are fiberoptic types such as Williams FireSights or the Tru-Glo sights. I dont know of any specific target applications.
The .17 HMR is a very flat shooting cartridge. To sight your rifle in place a target (paper plate will work) up at 25 yards. Start with a steady rest on a solid table or bench and shoot at the paper plate to see where the bullet is impacting on the target. Move your sights until the bullets hit in the middle of the paper plate. Once this is done your rifle will be sighted in at 25 yards. Next, move your target to the distance where you feel you will be shooting most often and see where the bullets impact at that distance. Move the sights, if you need to, until they impact in the middle of the paper plate.
A Smithh and Wesson model 19-2 revolver with a 6 barrel with Target sights and hammer can range in price from $50.00 to over $200.00.
Are you Aiming carefully
It is the image that a shooter sees when looking through the sights of a firearm at a target, and shows the alignment of rear sight, front sight and target.
The process of "sighting in a rifle" means to adjust the rifle's sights so that the bullet fired from the gun goes where the sights are pointing. One would normally mount the gun in a vice, fire a shot at a target set at a fixed distance away and then adjust the settings on the sites so that the cross hairs intersect over the hole made by the bullet.