0
Why are you not getting 12 volts to your passenger side headlight on your 2003 Volvo S40?
Wiki User
∙ 12y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How many volts run to headlight of 1997 Lincoln mark viii?
12 volts...max 13.8 volts
What is the voltage supposed to be in the headlight of a 1998 chrysler concorde?
12-14 volts
Your Honda xl250s headlight bulb pops when revs engine?
Check your regulator. It controls voltage to the headlight. If it is defective you will get way more than 6 volts to the headlight above 3000 rpm.
How many volts should your fuel pump be getting?
12 volts DC.
Why does drivers side headlight show 13 volts at plug but won't light?
It can either be a blown Bulb. Or it could be bad or corroded connectors.
Can you put AC to a 1977 Yamaha enduro 100 head light?
Yes, but not more than 13 - 15 volts, or the headlight filament will burn out.
How do you get 12 volts off a 24 volt dc system?
One way in achieving this can be getting a 140 watt solar system. The reason behind this is they take both 12 volts and 24 volts.
Horn does not work on your 2004 stratus fuse is ok?
check the voltage at the horn and see if its getting 12 volts. If it is getting 12 volts then the horn is no good. If its not getting 12 volts then the wire from the horn needs to be traced back to see if there's a break some where in the positive wire. try checking to see if the horn button on the steering wheel is working properly.
Why am I only getting 1.5 volts max to the rear window defogger when I should be getting 6 volts I have 12 volts going into the def. switch and 6 volts leaving the switch.?
lol. 12v in, only 6 out. looks like your switch is eating 6 volts. Get that out of there. then the other volt drops should come into check. You should only have a .5v total volt drop in the whole circuit; after that problems start to pop up.
If a 1981 Lincoln Town Car is getting 10 plus volts to the distributor but no amps what could cause this?
i think you should try a new alternator buddy. u shold be getting 14+ volts maybe that will work :)
You are getting 110 volts after the circuit breaker but only 50 volts at breaker why?
you have a magic power-generating CB find out how it works and you should make a fortune.
How do you plug in a pot that is 220 to a 110?
Use a step-up transformer from 110 volts to 220 volts. Try getting one at Home Depot or SEARS.
