This is the little box located behind the radio if you enter your hand where your radio would be you could see what iam talking about, also if you press the button on the shifter and don't let it go and play with it while in park the light would come on i hope this works for you.
ANSWER
start your car(or at least put kjey in second position) put it into gear(or if still off just move into neutral) and put back into brake, pull e brake and turn car off and remove key.
Besides the obvious possibilities of faulty hardware, there is a push button release. If in fact the switch is broken or faulty, there is lock smith services in most areas that will come out to the vehicle and replace the entire ignition key unit.
how do you replace a ignitionswitch tumbler 1991 buick skylark
The 1991 Blazer has a current draw causing the wire to burn. You will need to trace the wiring out to find what is drawing too much current.
No, a 1991 Chrysler New Yorker does not have chip key.
Regarding a model 1997,2 liter sonata, there is not an ignition control module as such. Ignition control comes from the ECM (ELECTRONIC CONTROL UNIT) through the Ignition Power Transistor (often called Igniter) and then to the Ignition coil.I do not have any information on the 1.8 or the 3.0 liter models.
http://www.therangerstation.com/tech_library/TFI_Diagnostic.html Heat
how to install a altinator on a 1991 acura integra
wiper intermittent relay 1990 acura integra
Yes, It will fit a 90-93
The Parts you need for 1991 Acura Inegrahttp://www.autosparepartsusa.com/searchparts.aspx?make=58&made=Integra&year=1991
1,3,4,2
Yes.
not likely if your talking about 1991 as being the DA integra and the 1996 as being the DC2
The 1991 Acura Integra idle air control valve can be found on the firewall. The valve will be on the drivers side of the firewall.
The 1991 Acura Integra brake lamp number is 2057. See sources and related links below for a picture and more information.
any color you want
this means your starter is bad
An H22 or K20.