Because more things got invented, therefore people had more things to build a house with.
Colonial Maryland had O.K. housing for that time, but it definitely wasn't great. The homes were crudely constructed, and varied in sturdiness between the classes but the average house was only expected to last ten years.
The latest one, the Housing Act of 2004, updated the housing standards of earlier versions.
Fair Housing Act of 1968
Settlement Housing.
terrace housing
Change in the expected future price of housing.
maybe the housing can change human life
To change the thermostat in this Lexus model, follow the upper radiator hose to the aluminum housing--the thermostat is located in that housing.
If you have fog lamps on your Jetta,between the foglamp and the Signal lamp there is a reflector. Pyy gently with a flat head screwdriver and the reflector will pop out. Then you will have acess too the signal light housing. There is a spring there,push it towards the housing and pull the housing out. Twist and turn your bulb uot of the housing......
Below the intake manifold (the large air duct where you change the air filter), is the thermostat housing. The heater hose runs out of the thermostat housing, over the exhaust pipe, to the firewall between the engine compartment and the passenger compartment. Some have a metal section of pipe connected between the thermostat housing and the typical rubber heater hose.
The bell housing is between the engine and the transmission.
The minimum distance between the housing properties in the United Kingdom is 21 meters. This is to enable the house properties have ample space between them.
You get under the running boards right under the lights. there is a little plastic housing. pull this housing down and change light bulb is that easy.
To change the headlight on a 1985 Honda Spree scooter remove the headlight housing. The scooter headlight will be mounting on the rear of the housing. Remove it and replace the bulb.
change entire housing. $100 part. sorry.
nffiukdsfcsyai
Subaru Forester does not have cornering lights, so chances are you are asking about the front parking light. The housing is held on by one screw accessible under the hood. You then pull the housing toward the front of the car. Bottom of that housing has a ball stud that fits in a socket on a small ear on the headlamp housing. This will allow you to either change the bulb or change the entire housing. --Ken