The belt need to be replace to a new oneor check the tention of the belt.
Loosen the tensioner pulley. Slide the tensioner pulley to the right. The serpentine belt will come loose. Remove the serpentine belt. Reverse the process to install the new serpentine belt.
Loosen the tensioner pulley. Pushed the tensioner pulley to the left. The serpentine belt will come loose. Remove the belt. Reverse the process to install the new serpentine belt.
belt tension er spring
Loosen the tensioner pulley on your 1988 Chevrolet Corsica. When the tensioner pulley is loose the serpentine belt will easily come off. Put the new serpentine belt on and tighten the tensioner pulley.
Removing the serpentine belt on a Pontiac Aztek requires loosening the adjustment pulley. Once the pulley is loose the serpentine will have enough slack to come off.
Many things can cause a serpentine belt to come off. Most likely, it slipped off, or the tensonier that holds it in place was not tight enough.
Loosen the tensioner pulley. Slide the tensioner pulley to the right. The serpentine belt will come loose and can be removed. Reverse the process to install the new belt.
You probably have a bad serpentine belt and tensioner.
Yes, it will come off if driven through an large puddle of water. It had happen to me with my 1998 T @ C.
Possibly, if the alternator is driven by that belt and it is setting a voltage code.
the head will need to come off, thread the belt through and, and tilt the head so that you can slide the belt on
The belt that I used my my 1999 ford escort ZX2 is a 6K730 to bypass the A/C. when routing the difference is the belt will come from the power steering to the tension pulley to the crank then water pump and the rest is normal. I hope this helps