0
Why did your transponder key quit working after you change the battery?
Wiki User
∙ 12y ago
Most likely the reason is when the battery is disconnected, there is no power to the PMC. On this car, you may have to reset the code, or chip...Try to disconnect the negative cable, and have the key in the ignition (KOEO), it may wqork...Tom..
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you know when your battery is drained?
when the electronics quit working.
2000 Buick Lesaber after battery change all windows and door locks except driver quit working any ideas?
take it in to have the codes reset. they were set off with the battery change.
Why would my 2008 Honda pilots keyless remote quit working?
Replaced the battery in the remote.
How do i reset your key for your 2005 Buick Lacrosse?
I got a new battery for the engine and my remote quit working.
2001 explorer power windows quit working?
This requires a lot of battery power. First, check your fuses. You may have blown them(one). Then check your battery for a charge.
Why did your remote start quit working and the engine light come on?
It is possible the battery in your remote is dying...that signals a fail to start and a Check Engine Light for low remote battery voltage
Why my sound quit working?
We need more info simply other than your sound quit working
What could the problem be with the tachometer it quit working on 2001 Chrysler TC?
A wire going to the battery broke off, when it was reconnected the gauges and lights on the gauges start working again, however the speedometer and the tachometer did not operate.
Why have your wipers stopped working?
The motor may have quit working .
How do I repair my automatic garage door?
Chances are it's the battery in your remote that has quit working. Before begining any major repair job make sure you check the batteries.
Why Battery light came on and then car died?
Most likely the alt. quit. The battery ran out of charge. Charge the battery, start the engine, and check volts on the battery, anything less than 14 volts, like 12.3 or so, check wires, and most likely change the alt.
Should I quit my job or keep working?
No. You should not quit your job but you should keep it.
