0
Why do the high beams not work even though running and normal beams work fine on 2001 Sunfire?
Wiki User
∙ 16y ago
Does the car have fog lights? I have a 2003 Sunfire that the high beams would not work on. This was caused by a short in the fog light wiring. I had the fog lights rewired separate from the harness (about $100) and the problem was fixed.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
If the high beams on a 1998 Sunfire do not work but the daytime running lights do is it because they are on the same element?
Seperate circuits I believe.
Why do Low beams work high beams don't indicator light on all the time in 1996 Pontiac sunfire?
Normally caused by faulty dimmer switch.
2000 Chevy Cavalier low beams do not work but day running lights and high beams work what could be wrong?
As a guess both low beams are burnt out The daytime running and high beams are the same light filament. Or the fuse or the relay for the low beams.
Why are my day time running lights and low beam lights not working but my high beams work on my 2000 sunfire gt?
I have a 98 sunfire gt and i have only high beams which only switch on sometimes and no low beams just day lights my shop told me it could be wiring or turn signal switch they looked and determined it was the switch so i just ordered it. They can be found on carpartwholesale.com or autopartwarehouse.com for only 30 or 70 with cruise control. only need a torx wrench and small screwdriver to replace it just snaps into the wiring harness.
Headlights go out on Pontiac Sunfire 2000?
It might be the high/low beam switch. Had to replace one on my '96 when I had only low beams.
Why wont the daytime running and low beams lights work when I have high beams and have changed both lights and the switch?
Have you checked the drl relay?
Low beams on 1997 sunfire don't work and already replaced the switch 3 times?
the problem is the switches themselves, just poorly designed.
What beams should I use when I am driving at night with my 2004 BMW 530i?
In normal traffic always use low beams. High beams are for greater visibility forward when there are no oncoming vehicles.
If the daytime running lights are out on 2002 Pontiac Sunfire sedan but headlights work and service lights come on when running lights try to go on how can you fix this on your own?
you need to change the bulbs Once the running lights burn out the rest of the bulb doesn't work right one of my low beams went out and the running light would flash a light out display and the rest of the lights would work right. I replaced it and everything went back to normal You can also try replacing the DRL (daytime running light) relay in the fuse box on the side of the dash. It pulls right out...$12 for replacement. From my experience the problem may not have to do with the DRL, but with the turn signal switch / headlight switch module. These are approximately 59.00. You will need a steering wheel puller, screwdriver (flathead), and possibly pliers. Be sure to disconnect the battery before servicing though.
97 sun fire and the high beams work but the low beams don?
Not uncommon in that model; apparently the wiring harness is weak at the low-beam wire; read more in the forum below. gminsidenews.com/forums/f53/1997-pontiac-sunfire-headlights-40665/
Why do daytime running light on 1996 Pontiac Sunfire not working It's not the relay or the bulbs?
Do your headlights work? High beams more specifically? If that answer is yes, then the bulbs are fine. DRLs are nothing more than a lower voltage being sent to the high beams in the Sunfires. (They use 9007 HB5 bulbs, which is a dual filament. highs and lows in one bulb). IF the LOW beams work, but not the high, try new bulb. Otherwise its off to try and find that relay... which is a pain in the ass. Personally, I pulled my relay out and never put it back in (I have HIDs in the car now).
The high beams on my 2003 Pontiac Montana aren't working. Low beams are though. Any thoughts on what happened?
you may have a bad relay. If both of them are out, that is probably the relay for the high beams or it could also be a fuse.
