Makes it easier to tighten the filter by hand by reducing friction.
When you replace your oil filter it come with a new gasket. Just make sure when you remove / replace the old oil filter the oil gasket comes out with it.
The oil filter gasket is built into the filter itself, so just by changing the filter, you always get the new gasket.
Gasket should be included with new oil filter
Here are a few reasons for oil to spray from the filter area:The gasket from the old filter was stuck on the oil filter housing and was not removed before the new filter was installed.The new filters gasket is not seated correctly on the oil filter housing.No Oil filter gasket was installed with the new oil filter.Defective Oil Filter and/or Gasket.Oil Filter Housing came lose from the engine block or mounting surface.
You unscrew the old filter, wet the seal on the new one with oil, and screw the new one on hand tight.
The gasket comes preinstalled on the new filter. Make sure the gasket comes off when you remove the old filter. Apply a think layer of oil to the new filters gasket before installing.
Oil coming from the oil filter area usually means that the gasket for the oil filter is not seating right. If the filter was changed recently, the old gasket could have been left on, along with the new gasket, causing a bad seal.
The oil filter gasket is a rubber ring that is usually bonded to the oil filter. If the oil filter has been removed and has no gasket, then it has become stuck to the engine block. Remove the gasket from the block before installing a new oil filter with it's own new gasket. Be sure to spread a little clean engine oil on the rubber gasket before installation to help seal and prevent sticking to the block. Do not overtighten the filter, turn the filter until the gasket contacts the block and then tighten 1/4 turn more. If the gasket leaks, tighten just enough to stop the leak.
An oil filter gasket is the rubber seal at the bottom of the oil filter that seats on the engine.
Not applying a film of oil to the gasket before installation. Grit or dirt on the gasket or mounting surface. Over-tightening the filter. Only tighten 3/4 turn after making contact with the mounting surface.
Replace the gasket with a new one.
the gasket comes built in with the oil filter period! there arent any gasket except the one on the filter . find a new mechanic!