Because you probably pushed either the lock or unlock button on your key fob
emergency blinker
the alarm
You have a faulty headlight switch. It's too much of a load on the headlight switch to run all the lights at the same time. You should run a separate light switch for the running lights.
It is used to flash running lights after a pass is made on the freeway. Like the truckers do after they pass a truck.
Why does my heater control lights flash on an off on my 1990 Z71
If dash and parking lights do not work - check the fusesMay also be a bad headlight switchThe tail lights and brake lights on my 2002 would not work at the same time. Had to replace whole tail light assembly. Was told problems with jeeps-the circuit boards in older jeeps overheat and short out.
u have a blown headlight. change both bulobs and it will stop.
you have a short to ground . have it check soon ! could be a door switch .
indicator stalk problem, fit a new or good second hand one to cure
cuz they are!
They should come on automatically when the vehicle is in operation. If they're not, you might have an electrical problem. If your vehicle is a U.S. vehicle and you want daytime running lights, you must purchase a daytime running lights (drl) module for about $50. and place it in the fuse area off the driver's side dash. Remove the hi beam module and then find someone with a Jeep/Chrysler computer that can flash your computer board and change the country code to Canada and voila, you will have daytime running lights.
they flash lights