0
Why does 1000 watt amp go into protection mode on 2 speakers that have a 400 watt peak apiece?
Moondizzle
nope most likely a ground check your ground and wires worst case check ground on body of amp with a screwdriver
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What is Protection Mode on Computers?
alt+delete+control is proected mode.
What is hardware protection mechanism in operating systems?
CPU protection Memory protection I/O protection Dual mode protection. Research more about these and maybe you will get where you are going.
How do you fix ipod speakers to not be on speaker mode?
lower the volume or plug in some headphones
Is it possible for an amp to go into protection mode from overheating?
yes...yes it is
Where do I buy property protection in Mafia Wars?
the property protection is available on the properties page. at this stage you do not need property protection because the robbing mode is disabled.
If a pool is in the service mode will it still go automatically into freeze protection mode when it starts freezing?
No, the service mode on A jandy or pentair system, is just that for service the whole system is shut down in service and the equipment can only be turned on manually. So in other words the "freeze" protection has been turned off in the service mode.
What is Hardware protection dual mode operation?
define and explain hardware protectoin
How long does a letter take to travel 1000 miles?
That will depend on the mode of transport.That will depend on the mode of transport.That will depend on the mode of transport.That will depend on the mode of transport.That will depend on the mode of transport.That will depend on the mode of transport.That will depend on the mode of transport.That will depend on the mode of transport.That will depend on the mode of transport.That will depend on the mode of transport.That will depend on the mode of transport.
How does the distinction between monitor mode and user mode function as form of protection system?
The distinction between kernel mode and user mode provides a rudimentary form of protection in the following manner: Certain instructions could be executed only when the CPU is in kernel mode. Similarly, hardware devices could be accessed only when the program is executing in kernel mode. Control over when interrupts could be enabled or disabled is also possible only when the CPU is in kernel mode. Consequently, the CPU has very limited capability when executing in user mode, thereby enforcing protection of critical resources.
What does a protection diode do?
It will conduct electricity when the voltage across its terminals reaches a certain value. Once the over voltage is extinguished, the protection diode becomes an open circuit again. Therefore, you need to connect a protection diode between both wires to be protected (differential mode) and from each wire to ground (common mode). Protection diodes are primary protection devices (fast reacting), but they cannot handle too much current. That is why they need to be used with secondary protection devices (fuses and gas arrestors) to provide better protection.
What are rings in Windows NT?
Windows NT uses protection mechanism called rings provides by the process to implement separation between the user mode and kernel mode.
Why does your amp go into protection mode?
This is to prevent damage. You may have something not connected correctly or parts that are not compatible.
