if your turn signals dont work but your hazards do...check the fuse behind the radio.it looks like your hazard flasher.(should be blue, mine was).if not, make sure that the wires are fully seated in the ignition module on your steering column(its right below the ignition, that you put your key in)..if there loose, get a zip tie and secure it on the ignition module..
Check the fuses.
Check the signal light fuse, the signal light relay, and the signal light switcher.
the fog lights work with the low beams , they wont come on with the high beams
If it's not the bulb or the ground wire, check the connections. If all else fails, it's the turn signal switch.
Believe it or not, I have had to disconnect the cig lighter in order for the tail lights to work. Sounds far fetched but it does work!
Could be the control stick for the blinkers. If the lights work, try replacing the stick or checking out the signal path for that blinker
It could be a bad ground, also check the fuses its a 14A Fuse in the top of the block and all the lights (if one light is out that side wont work)
There are separate fuses for trailer signal lights in main fuse panel
did you change the flasher? it looks kinda like a film canister, under the dashboard by your feet
on the back of the car
Fuse
Look for either a blown fuse or replace flasher unit for the signal lights (it is separate from the hazard lights flasher unit).