answersLogoWhite

0

Add your answer:

Earn +20 pts
Q: Why does Acura CL shifts hard when cold. Its a 1999 3.0 Acura CL auto trans. car shift good when motor is hot but shifts hard when cold. Also when coming to a stop when cold it joints forward?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How much does it cost to replace ball joints in an Acura?

It will cost approximately $180 to replace the ball joints on your Acura. The cost is dependent upon many different factors.


What type of tranny fluid on a 2002 acura?

Use nothing but OEM Acura or Honda ATF DW-1 automatic transmission fluid. Do not use any other fluid that claims to be a replacement or you will suffer rough shifts.


Why does your 1992 Acura integra produce squeaking noises while the car is in motion and turning?

Check your brakes and CV joints


When is the 2009 Acura MDX coming out?

In two weeks from now. By September 1st week.


2001 acura 3.2 cl has code p1709?

i have a 2001 acura cl 3.2 and the code p1709 keeps coming up and the drive light flashes. how do i fix this


Why hesitate shifts 1989 Acura Legend?

It could be a number of things going wrong. Try dropping the transmission pan and changing the transmission oil filter and transmission fluid.


Acura Legend 91 over heats?

Explain what it is doing! is water coming out of the tail pipe? do you see white smoke coming out of the tail pipe?


Can 20 inch rims fit 1997 acura tl 2.5?

yes, but make sure you change your stock ball joints to adjustable ones


How do you replace rack and pinion on a 2003 acura tl 2.3?

Lift the Acura. Drain the power steering fluid. Disconnect the steering joints from the power steering rack. Unbolt the race and remove. Install the new rack and connect the steering back up.


If your Acura Integra automatic transmission shifts rough what can it be?

It may just need a fluid/filter change and then again it may be a more serious problem. My advice is to take it to a Acura/Honda dealer or trusted transmission shop for service immediately. Continuing to drive in this condition may do serious damage to the transmission.


1988 acura legend s3 light flashes and will not shift past 3rd gear TCU code is 4?

1988 Honda acura legend S-3 light keeps coming on what should I do


How do you remove the Acura Vigor front brake rotor?

How do I remove the front rotors so I can replace the CV joints? .... After removing the brake pads and caliper assembly, of course.