answersLogoWhite

0


Best Answer

Replace the shear pin.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does Johnson outboard motor run well but the prop doesn't turn?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the value of 1996 175 hp mercury outboard motor with SS prop?

$1000


What is the weight of a 1998 mariner 200 outboard motor?

398lbs +prop and oil,gear lube 446lbs


What size prop comes on a 90 Johnson?

The 90 hp Johnson outboard is not shipped with a propeller installed. The correct size is determined, and installed, when the engine is rigged on the boat.


How much horsepower does a 4.0 Mercury boat motor have?

A 4 hp Mercury outboard, produces a true 4 hp, rated at the prop.


Evinrude 25 horsepower outboard prop slips while under a load. Or could it be cavitation?

Sometimes the center of the prop breaks loose and slips or the splines get stripped. Also check to make sure you have the correct pitch prop for that motor and it is fastened securely.


Should an outboard prop spin while in neutral?

In neutral, the propeller shaft is not engaged with any other part of the motor so the prop will spin freely. You'll often see this when a boat is being towed down the highway - the prop is spinning the same as a windmill does in the wind. It's best to let it spin cause if you put the motor in gear and the prop hits something, such as your driveway while you're going in or out of your yard, there is no give and you could damage your prop or worse, the gears inside.


What is the weight of a 1991 Yamaha 150 outboard?

401.2 without prop


Will a 3 hp outboard push a 14 ft aluminum?

Sure! So will a trolling motor. Maybe not as fast as you'd like, but as long as you keep the prop out of the weeds, you'll move.


Where is the impeller on a 2.2hp mercury outboard?

right behind the prop, on the same shaft


Does a Johnson 135 outboard motor have enough power to pull a water skier?

It all depends on your boat first and the actual skiers to a lessor degree. If you have smaller ski or fishing boat (19' or shorter), then that is more than enough power to pull whatever or whoever you want to with it. I am 6'1" and stocky in my earlier days, but I have skied behind a 17' bass boat with a 70 hp outboard pretty effortlessly. If your boat is 20' or larger, then it comes down to the weight of your boat, the type of prop you have, etc. and it is less likely that you will be skiing much with that boat/motor combination. **Worse case, try it... You will either pull the skiier up, or not. Remember too that you can change your prop to a power take off prop that will give you more BITE from a dead stop for this situation, but takes a little of your top end speed away.


How can you make your 50HP Tohatsu outboard go faster?

change the prop pitch nah done that. its to do with the engine.


What size prop comes on a 125Hp Force outboard?

The propeller size on an outboard engine, is dependant on the application. The size of the boat, and more particularly the weight it will carry, determines the propeller size.