Cars & Vehicles
GMC Yukon
Ford Windstar LX

Why does Traction Control come on during all left turns 2000 LX?

456

Top Answer
User Avatar
Wiki User
Answered
2010-03-20 05:12:56
2010-03-20 05:12:56

i just had mine into the dealer for that and he is telling me I need a new ABS computer module

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The 2000 Cadillac traction control module can be found on each wheel. There is a total of four traction control modules.

where is the fuse for the traction control module located on a 2000 Cadillac Seville

The 2000 Pontiac Firebird is equipped with a traction control switch on the shifting console. The traction control button can be pushed in and out to turn the system on in off.

On my 2000 model focus, when the light is on permanently, this means the traction control has been turned off.

You can switch the traction control system off using the switch to the left of the radio on a 2000 Ford Windstar

The traction control system has engaged and is applying the brakes and / or altering the power to the drive wheels to control wheel slip. Read your owners manual for specifics.

The traction control shouldn't affect the break system. The operation would only be affected by warmed rotors or bad calibers.

The "trac" button is for traction control. By default, traction control is always on unless you turn it off.

I have a 2000 venture and the traction control light came on. Where do I look first, hubs. Wiring.

It is Traction Control System. it pulls timing if you are spinning.

my 2000 Cadillac Deville did the same thing. all i did was to turn switch off turn car off counted to 60 turn car back .on light has not come back on

a sharp jerk to the chassis usually will trip the light on

It should be a toggle switch right above the radio

Yes, a 2000 Trans Am does have posi traction. If a car has posi traction, it means that the car has a limited slip differential. Posi traction is good to have when traveling in ice or mud.

you cant bad speed senser in one of the wheel bearings is abs light on?

There is TC button near the gear stick, but if is not, then you have to make it by yourself.

In the 2000 model you press the button just behind the stick shift on the center consel.

Do you mean"trac off"? this means the traction control is disabled

You should suspect the rear brakes for this one...maybe at their wear limit and keeps the light on....Possibly the front brakes...This IS a 2000 model.

Just press the Trac Control switch on your dash. It toggles traction control on/off. The location of the switch is shown in your owner's manual. Cheers

Inside glove box to the left of storage area on the facing is a small round traction control button that looks like a trunk button. From what I can tell it will automatically go back on next time you start car which is good for safety.

It's possible one of the ABS / Traction Control wheel sensors was knocked off line during the transmission operation. I would suggest asking the repair shop to inspect the front sensors and double check they were plugged back in & the wiring looks okay. If they are equipped to read ABS trouble codes, that would be very handy - otherwise, you'll have to find a good tire shop / repair shop / dealer to check for any error codes to diagnose why your traction control light is on. See "Related Questions" below for more

It is your choice. If you want the Traction Control to be activated then I would just leave it on. I never turn mine off.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.