A bulb does not light up if there is no voltage available across the bulb, or if the bulb is burned out.
No. The light bulb is two words, not a combination of light and bulb.
Because there is a light inside of the warmer, and you see the reflection from the light.
A light bulb that uses a filament is also known as an incandescent light bulb.
Thomas Edison invents the light bulb.
check your wireing for a short in it or make sure the socket isn't bad and the bulb is in tight
I have seen it both ways. Usually it is the bulb which is a few bucks. The ballast will cost more and could cost $15-$30 bucks depending on type. If you have another bulb that is working, swap it with the flicker light and see if the problem goes away. If the swapped bulb works, I always put the bad bulb in the fixture where the good bulb came from. If the bad bulb now works, you could have a seating problem with the bulb. If it flickers, replace it.
no
All other things being equal, an incandescent light should not "flicker" whether it is connected to 120 or 130 VAC.
flicker
Loose bulb or loose connection.
If all of the lights flicker I would check for a loose or corroded ground. If only 1 light flickers then check to see if the bulb is properly plugged in to its socket, or if there is dirt, corrosion or rust causing a poor connection.
Yes it will with a regular Edison bulb but when it comes to the cfl and florecent tube lights well their gases can settle and cause that dancing light or flickering if seen through a shade with those just remove shake and replace but they also can flicker with voltage changes but they need a more significant voltage change to be noticeable
if they flicker then most likely another turn sigal on the same side is bad or the bulb is blown
A flicker, a beam, a ray.
I installed spiral fluorescent light bulbs and a motion activated light switch for my kitchen light and noticed that it flickered when it was inactivated. From what I understand, the motion switch doesn't stop the current completely; it uses a small amount to run the motion sensor. That small amunt of current will build up in the flourescent bulb and discharge causing it to flicker. Fortunately, the light fixture I had held two bulbs and I simply replaced one of the two spiral fluoresent bulbs with a regular incandescent bulb and the flickering stopped. Based on that,I assume some current is still getting to yourlight bulb which is causing it to flicker.
Thomas Edison is best-known for the light bulb.