0
Why does fuel pump stop working when Motor gets hot on 1990 Plymouth acclaim 3.0l?
Wiki User
∙ 10y ago
Check the fuel pump relay. It's on the passenger side fender between the battery and strutt tower. Have someone turn the ignition to the run position (don't start the engine) while you listen, the fuel pump relay will click when it turns on. Run the vehicle until the pump stops working and check for the click again. If it doesn't click replace the relay.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Does a 1990 Plymouth acclaim have points and a rotor?
Points, no. Distributor cap and rotor, yes.
Where is the water pump located on a 1990 Plymouth Acclaim?
It is under the timing cover on a 3.0L
What type of oil to put in a 1990 Plymouth acclaim?
5w30 or 10w305w30 or 10w30
What causes the cluking in the front end of a 1990 Plymouth acclaim?
Check lower control arm bushings.
Where is the Asd on a Plymouth acclaim?
On my 1990 it is the middle relay on the left fender between the battery and the shock tower.
Where is the O2 sensor on a 1990 Plymouth Acclaim 3.0 liter 6cyl?
It is screwed into the exhaust behind the engine.
Where can you find an electrial schematic that shows the speedometer wiring for a 1990 Plymouth Acclaim?
You can buy a motor manual with one in it at your local auto parts store or possibly find one at your local library and copy it there.
Where is heater core in 1990 Plymouth acclaim 2.2L?
The heater core is inside the Hvac housing, under the dash.
How do you remove the door panel on a 1990 Plymouth Acclaim?
Email me at:shughes@gcronline.com. I will give you what you need to know. Lynn
Will the digital dash cluster in a 1990 Chrysler lebaron sedan work in a Plymouth acclaim?
no it will not i was working on one for a dughters first car and she wanted a digi dash the components for the digi doesnt exsist sorry
What do you need to do if your speedometer stops working in a 1990 Plymouth acclaim?
Replace the speedometer cable. Better yet, replace the car. I had this problem in my 94 acclaim. Somehow it had gotten severed and no new part was needed. Take it to a mechanic you trust and all it will cost you is labor. No need to replace the car.
Where is the high beam switch on a 1990 Plymouth acclaim?
Pull the wiper/turn signal stalk towards the back of the car.
