Try to determine the substance: i.e.
Transmission Fluid (bad radiator)
Engine oil (bad head gasket) Try flushing the cooling system
and tracking other fluid levels
The thermostat on a 2004 Chevy Venture is changed by draining the radiator, removing the upper radiator hose, and unbolting the thermostat housing. The old thermostat and gasket can then be removed and replaced.
The thermostat on a 2001 Chevrolet Venture 6-cylinder 2-wheel drive car is located where the radiator hose ends. A replacement thermostat for a 2001 Chevy Venture is priced between $8.00 and $11.00 depending on where you buy it.
follow the top radiator hose to the engine. its under the cover.
The top radiator hose is above the thermostat. If the top radiator hose is hot, the thermostat is opening. The thermostat is not the problem. Perhaps the radiator is clogged up or the water pump is bad. Look elsewhere.
This may seem silly at first but, follow the upper radiator hose it's terminal end. There you will find your thermostat. Hope this helps. Sean
The drain plug on the 2003 Chevy Venture is located on the bottom edge of the radiator. It is on the side facing the engine.
The thermostat is located on the driver's side of the engine. The thermostat and thermostat housing is mounted on the lower intake manifold. You should be able to follow the radiator hose up to the housing. It is a little hard to see however. Mike
The radiator drain plug on a 2004 Chevy Venture is located at the bottom, left side of the radiator. It allows for the coolant to be quickly drained during maintenance.
The thermostat on a Chevy 350 is under the housing at the engine end of the upper radiator hose.The thermostat on a Chevy 350 is under the housing at the engine end of the upper radiator hose.
Usually in a removable housing at the engine end of the upper radiator hose. Yes, it is located in a housing under the throttle body.
yes
The thermostat on a 2005 Chevy Equinox is changed by draining the radiator, removing the upper radiator hose, and unbolting the radiator housing. The old thermostat can then be removed, a new gasket installed, and the housing bolted down.