0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why is a '87 Jeep Comanche cranking but not starting when you have even connected it jumper cables?
The Jeep has a TDC sensor on the bell housing that tells the computer when the distributor is at top dead center (TDC). If it is inop the jeep will not run
How do you adjust idle on an 89 jeep Comanche with a 4-cylinder?
theres a cable connected to a little turny thing near the front and center of the engine at the top. thats the throttle, its what your gas pedal controls. on the turny part there is a screw that the assembly is resting against, the idle adjustment screw. run the engine and adjust the screw til you get the result you like. I have done this on my 89 jeep comanche to make it easier to drive cause when I was new to standard. dont adjust it to high or low though. I would stay within the 700 to 1100 rpm gauge or it can be bad for your engine or environment. hope that helped
What makes 1993 Nissan truck run at fast idle?
I would check for a vacuum leak first, then the idle solenoid which is located on the side of the intake plenum.
Why does my 1982 Jeep Cj-7 258 straight 6 run rough at idle but smooth at cruising?
check your plugs........
How do a just idling on 1992 1500 truck?
You can adjust the idle air control valve on a 1992 1500 truck while it is just idling. This is done if the truck is idling too fast or too slow. It will help the truck run better.
How do you turn on the cold weather high idle setting on a 2002 Chevy duramax?
to turn on the high idle you must run a wire to the ecm /www.kennedydiesel.com:.webloc if you go to this link it will give you the instructions to do it. I did it on my truck and it works great !!! if you have a car starter with an available output you can connect it through that and run you high idle from that.
Is it necessary to keep the brake lines connected to the height sensor on a 1990 Jeep Comanche or can i plug the return line and just run one to the rear breaks?
you can, but it will mess with your brake bias %.
What is normal oil pressure for a semi truck?
Varies by engine. A Cummins will run about 40 at idle, whereas a PACCAR MX will run about 80.
1988 Chevy truck wont idle and stalls when put it in drive but will run if you hold the gas down in park i put new fuel pump on plugs and wires and cap.?
Carb needs curb idle adjusted or rebuild.
What is wrong with my 2003 silverado it idles rough and will go dead when put in gear?
its most likely your idle control sensor. if you replace it the truck should run fine.
What could cause p1000 code rough idle on 2001 Ford Ranger 4.0L Truck runs fine above idle but stalls at idle?
P1000 on any ford means you have cleared the PCM codes and it hasn't run it's self-diagnostic tests yet. This will go away. It is not related to your rough idle.
How did Bella get run over by the truck?
She was never run over by a truck.
