answersLogoWhite

0

Why does my Zx2 Clutch pedal stick?

Updated: 12/9/2022
User Avatar

Wiki User

14y ago

Best Answer

clutch master slave cylinder just replaced mine and now it doesn't do it

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does my Zx2 Clutch pedal stick?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why does your Peugeot 207 clutch pedal stick down?

Fault with clutch master cylinder.


What is wrong if the clutch pedal does not come back up fully and gears stick?

You may need to adjust your clutch or replace your clutch.


What is the poor habit of resting your foot on the clutch pedal while driving a stick-shift vehicle?

Answer: "Riding the clutch"


What causes the clutch pedal to stick on a 2004 Wrangler Rubicon?

you might have a air in your clutch system or your clutch master/or slave could be worn.


On a 1990 Isuzu Amigo what would cause the clutch pedal to stick to the floor?

if its hydraulic there could be air in your line. bleed your clutch and refill.


Why does the clutch pedal stick to the floor?

You've blown a clutch hose by the sound of it, or you've got a leak in the clutch master or slave cylinder. Either way, without clutch fluid, the clutch pedal wont come off the floor and the clutch will be disengaged. Any half decent mechanic should be able to figure out what the issue is without charging and arm and a leg.


How do you adjust clutch pedal on 2000 Saturn?

The clutch pedal cannot be adjusted


How do you stop on manual car?

Put your foot on the clutch, move the gear stick to neutral and then put your foot on the brake pedal


How do you engage the clutch on a car?

The clutch pedal.


How to Adjust clutch pedal height peugeot 307?

To adjust the clutch pedal height in the Peugeot 307 locate the adjuster bolt on the floor under the clutch pedal. Loosen the bolt and pull out the pedal to the proper height then tighten the bolt. To make the clutch pedal lower for the operator simply push in on the clutch pedal while the adjuster bolt is loose, then tighten the bolt.


My 1998 s-10 2.2 stick shift will not start?

The clutch pedal must be fully depressed ... could be the switch that senses travel for that pedal needs to be replaced or re-aligned.


Why does your clutch squeak when you press it?

The clutch pedal usually squeaks where the clutch pedal is mounted under the dash. The clutch pedal pivots at its mounting point so it probaly just needs some lubed sprayed on it.