If your check engine light is flashing , an engine cylinder misfire has been detected
May also want to check the module ontop of the transmission, it's located next to the battery, I'm not sure if the part's correct name is a neutral safety switch.
The band that controls second and fourth gear has failed. Usually about a $400 repair at a transmission shop.
Yes, water can cause a misfire, which will cause the check engine light to flash.
Jumping the pin connector on the ECU will allow the check engine light to flash on the dash console. The check engine light will flash repeatedly and show codes.
An engine cylinder misfire has been detected
A flashing check engine light is an indication of a misfire.
because you have a problem with your transmission and it is now in limp mode.it is probley shifting hard into each gear to.. need to flush trans and reset computer
A flashing check engine light is an indication of a severe engine misfire.
If a check engine light is flashing that means an engine cylinder misfire has been detected
There is a single green plug under the hood on the passenger side of the engine, in the back next to the firewall, (there is also a 5 wire plug next to it, dont mess with that) take a wire with a spade connection and plug it into the single green connector and ground the other end. (connect it to the body on a clean metal spot) then turn the key on, but DONT start it. watch the Check Engine Light, count the flashes and pauses. EX. flash flash flash flash flash (repeat) this is a 3-2 code, look that code up and find the error.
If the check engine light is flashing it indicates that a cylinder misfire has been detected.
If your check engine light is flashing that means an engine cylinder misfire has been detected