Problem:
"OF.L" appears in the outdoor temperature section of the LCD.
Solution:
1) Wait until the current surrounding temperature cools down or increases. Current temperature is outside of the measuring range of the transmitter or has temporarity affected battery strength. The outdoor temperature will be displayed again once the current surrounding temperature is within the range of the transmitter.
After playing with mine for a while, i found that resetting the master unit, followed by the outside temp sensor, made the master unit pick up the outside temp sensor.
All house clocks with internal temperature gauges are automatically set to the temperature within the area. These gauges only tell what temperature the room is, not change the temperature, like a thermostat.
i don'tlike you
The lowest temp. is 331 degrees C. well that's usually it's regular temp.
-234
how do you change the day of the week? model spc1003
Temp does not display on Sharp Atomic Clock SPC 900
After playing with mine for a while, i found that resetting the master unit, followed by the outside temp sensor, made the master unit pick up the outside temp sensor.
Skyscan Atomic Clock Model 86722ALU needs a reset after a battery change, or needs a battery change.
Yes, it has an outdoor temp display.
85
1st make sure your batteries are still working on the outside receiver. Then go inside and take the batteries out of your inside receiver (the clock). Put the new batteries in the clock and wait for the outside temperature to set. DO NOT SET THE TIME or anything else until the signal is received from the outside temp. If you get frustrated, take the outside transmitter inside and when it blinks the red light that is when the signal is sent, so wait for that. Hopefully this works for you.
5w-30 outdoor temp. from & below 0 F (-18 C) to 100 F (38 C) 10w-30 outdoor temp. from 0 F (-18 C) to 100 F (38 C) & above temp.
With heat pumps supply air temp will vary with outdoor temp. The colder it gets outside the less efficient the heat pump will be (colder supply air).
possible temp sensor, need to scan it to find out.
After changing batteries and moving the clock the outside temp still does not register. could the remote have goe bad. It has worked for years.
12