Want this question answered?
You start out by not posting your intentions on the internet you retard!!
Normal wear and tear usually. If you have repeated head gasket failure, there is a problem with the surface or the torquing procedure
i suggest using ONLY a bicycle pump. Never any other kind of pressure and onlly 6 lbs. More will blow them out.
best guess is you need your top end redone or at least looked at. when a car has that problem it is called blow by . and that means worn out or damaged.ANSWER: Nothing is damaged or needs to be replaced. The above answer is correct that the problem is blow by. But that's all that's correct about that answer. When a cylinder fires, there is a small amount of burnt gasses that "blow by" the rings on a piston into the crankcase. In older cars, this was vented to the atmosphere. In newer cars and bikes, because of EPA requirements, this blow by gas must be vented back into the intake system. This "blow by" gas carries with it a small amount of oil. Harleys are notorious for weeping oil out of the air cleaner because of the "blow by" recirculation. Not a whole lot you can do about it (and stay EPA legal) except to be aware of it and clean the oil from the outside of your aircleaner occasionally.
Auction Kings - 2010 Blow Gun Wooden Harley 2-19 was released on: USA: 25 October 2011
Martin - 1992 The Closer I Get to You 3-6 was released on: USA: 6 October 1994
a washable sponge
It can happen if bike has not been started for awhile. Oil leaks past check ball in oil pump.
A hot wire is touching ground somewhere, it could be at the ignition switch or any other wire that is connected to that fuse. Chaffing is a common problem with motorcycles so look for places where the wiring passes close to the frame.
Blow Your Mind - Jamiroquai song - was created in 1992.
Blow Your Mind - song - was created on 1992-08-27.
I found that this stain remover works just as good.