Same thing happened to mine. I had to replace the whole thing. Mechanic told me it was due to a nonworking electrical wiring that was connected to the brake lights were out. Once you replaced the whole thing, it should be working.
If it still doesn't burn, check the ground of the light assy.
On a 1994 Honda Accord, the brake lamp comes on when a tail light is no longer working. The burned-out bulb needs to be replaced. The brake lamp will not come on after the bulb is replaced.
No. I am assuming that you first replaced the bulb? If you did replace the bulb, then I would check to see if you are getting power to the bulb socket. If no power is getting to the socket, you then need to find the break in the electric lines going to the socket.
The Integra uses a dual-filament bulb in the tail light, which has one contact for the running light (the lights you turn on at night) and another brighter one for the brake light (only goes on when you press the brake pedal). You have replaced the bulb with the wrong type. You will need a 2057 bulb for the Integra.
The brake light bulb on a Jaguar X-Type is replaced by opening the trunk and unscrewing the rear cover. The wiring harness can then be disconnected, the bulb removed, and a new bulb put in its place.
The brake light bulb on a 2007 Cadillac CTS can be replaced by opening the truck, removing the rear cover, and disconnecting the wiring harness. The bulb can then be twisted, removed, and a new bulb put in its place.
Your brake light is probably brake fluid low or emergency brake on. Rear brake lights are replaced by removing the lens and replacing the dual filament bulb.
check your brake fluid and if that's ok your brake pads'Answer:If the light says "Brake Lamp", it means you have a tail light bulb that needs to be replaced.
The marker lights and brake lights run on two different circuits, and usually light up two different filaments on the bulb. If both tail lights are out, either a fuse is blown, a wire is compromised, or both marker light filaments on the bulbs are broken.
check high mount brake wiring from trunk...
Remove the Phillips screws holding the lens in place, remove the lens, push bulb into socket and rotate counter-clockwise, reverse procedure to install. There are three light bulbs when the brake light column is taken out. If just my brake light is out, which bulb needs to be replaced?
Your brake light switch is faulty. It is very difficult to fit the new one as it is a one shot switch (1 chance of putting it in properly).