It is time to change the switch for a new one. Switches only last so long being turned on and off on a daily basis. Their mechanical parts get worn and the internal blades that open and close the circuit get loose. Time for a new one. Shut the power off at the breaker and exchange the wire positions one at a time to exactly the same position on the new switch.
There could be a series of problems. First, are all the wires hooked up? Is the bulb burned out? Is it just the switch that is not working? You should go and put in a new bulb, and see if it was just burned out.
A standard filament bulb works on the principle that it gets hot and glows when a current is passed through it. If the filament has burned out (blown) it is open circuit and no current can flow. Therefore you are not using any electricity even if the switch is still on It may still use power if it is a lighted switch. Find a licensed electrician at www.contraxtor.com
wiring diagram of one bulb in two switches.. example, if switch a- on then switch b- off the bulb is on, switch a- off then switch b- on the bulb is on, switch a- on then switch b- on the bulb is off, switch a- off then switch b- off the bulb is off..
An open circuit is one where the current is not able to complete the circuit. An example could be a light bulb connected to power but switched off, the circuit being broken by the switch, and considered "open." When flipping the switch On, it connects the power and the circuit is then closed.
You turn on two switches wait 5 min. and turn one of the switches off! go in the next room the cold one belongs to the switch you never turned on..the warm one the switch you only left on 5 min and the lite one to the switch that is turned on! you switch on one switch for a few minutes, one for ages, and dont turn the other one on at all. you go through to the other room, the bulb that is warm is operated by the first switch, the roasting hot bulb (that would burn your hand) is operated by the second switch, and the cold bulb is operated by the third switch.
It go out.
It will not work because it has to be closed so the electricity can go to the bulb.
the bulb will light up when current flows thru it if the switch is open no flow will take place
Use a normally closed (NC) contact switch rather than a normally open (NO) momentary contact switch.
it's bulb 3
Circuit Electrons flow form the positive end of the battery through the wire connecting the positive terminal to a switch. The other end of the switch is connected to one terminal on the bulb, the other terminal of the bulb is connected to the negative end of the battery. No electrons (current) flows as long as the switch is open. Once the switch is closed and if the battery has enough voltage and current capacity to make the filament in the bulb glow, then the bulb emits light (together with wasted heat). If the switch is open, no current flows through the entire circuit and the bulb does not glow.
it is because the energy flows through the switch and it makes the light bulb turn on and if the switch is open the energy will not flow it will stay in the place the switch begins
no because when you remove the lamp the circuit is still open; even if the switch is on
Usually it is by pushing the switch on the wall into the down position. If that does not work, turn the bulb until it does not make contact and fix the switch.
There could be a series of problems. First, are all the wires hooked up? Is the bulb burned out? Is it just the switch that is not working? You should go and put in a new bulb, and see if it was just burned out.
The simplist answers is that electricity needs to complete a circuit fully. It stops flowing because there is no complete circuit. The switch is a device for opening and closing the circuit. When the switch is in the off position the circuit is said to be open and electricity cannot flow.
Fuse, bulb, wiring, door switch, switch on overhead light.