Want this question answered?
I have a 2002 Chrysler Sebring convertible. If you turn off the ignition and remove the key while the headlights are on, then turn off the headlights, the headlights will stay on for 30 seconds and turn off. You can avoid this by turning the lights off before you turn off the car or by switching them on and off again.
If the bike was made after January 1, 1980, the federal government requires the headlights come on when you turn the key to the "on" position.
Turn the key, just like in other cars.
That means you need to check the head lights. Suprisingly enough head lights on cars cause most problems. Especially on Fords.
Push the key into the ignition. To remove, push in, then turn towards you to remove the key. I do not know how to remove and replace the whole ignition assembly in case that was your real question.
turn the key? no start? check the battery connections. clean them make sure they are tight turn the key no start? turn on the headlights if you have bright headlights, the starter may be the issue. if you have no headlights, look at charging the battery after battery charge turn the key tries to start or clicks probably a dead battery if the car turns over and just won't start do you have gas? If the car turns over and tries to start that means the battery and starter are good now you need to find out why you are not either getting spark of fuel.
Did they used to go off with the ignition? On most cars, the headlights will come on at any time by just turning them on. The car does not need to be running or the key turned on.
Yes, inasmuch as they turn off when you shut off the engine and remove the ignition key; and the standard daytime running lights come on when you're driving. You have to switch from DRL to headlights with a switch, though - but in my soob I just leave my headlight switch on all the time anyway.
is it a ford? push the key in further and then turn it
just unplug the negative side of the battery.
Step on brake first. Turn steering wheel slightly to remove tension on key.
Programming a new cut key is easy. Take the original key and insert it into the ignition switch and turn the ignition on. Then, turn it off and remove the original key. You then have 15 seconds to insert the new key and turn the ignition on. Leave it on a few seconds and then turn it off and remove it. That's it. You should be good to go with the new key now. I was.