2001-08 Silverado, Less Driver Information Center
These models are equipped with an oiling system indicator lamp which will flash if the oil level drops below a safe point or will remain lit when the oil and filter are ready to be changed.
After changing the oil and filter, reset the monitor by proceeding as follows:
Turn ignition On, but do not start engine.
Fully depress and release accelerator pedal three times within five seconds.
If CHANGE ENGINE OIL lamp flashes for five seconds, this indicates system has reset.
Start engine. OIL LIFE should change to 100%.
If CHANGE OIL SOON lamp lights again, repeat reset procedure.
2001-08 Silverado, w/Driver Information Center
Turn ignition On, but do not start engine.
Press MODE button until DIC (Driver Information Center) reads OIL LIFE LEFT/HOLD SET TO RESET.
Press and hold SET button until 100 percent is displayed. You will hear 3 chimes and CHANGE ENGINE OIL SOON message will go off.
Turn ignition Off.
Source(s):Alldata Technicians Referencethe warning lights comes on indicating that the timing belt needs to be changed. even once the timing belt is changed, the warning light will stay on until is it reset.
Auto Zone will check your engine codes for FREE. They will tell exactly what is causing your engine light to stay on. They may even reset it for you.
A chemical has changed appearance in both a physical and chemical change. It cannot stay the same or it wouldn't have changed.
You might have a bulb that is burnt out which will cause your signal light or even tail light to stay on
The Hebrew religion never stayed the same in any era. It has always been in a state of constant change.
Yes, the chemical properties of water will stay the same even when the physical properties are being changed (phase change).
it changed
More than likely it needs to be reset.
replace the sending unit.
This could be the result of a setting that you have accidentally changed. Try looking through the car manual to see the different light settings possible.
the fridge light! :) <><><> Tobasco Sauce!
if u changed thermostat it has to be reset so fan can turn on correctly