0
Why does the clutch on a 1988 GMC Jimmy leak fluid but will not shift into gear?
Wiki User
∙ 15y ago
It wont shift because its leaking fluid.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the clutch fluid reservoir for 1988 325i?
The clutch fluid is located in the same reservoir as the brake fluid. As a dot 4 brake fluid, used for the breaks and the clutch.
What kind of fluid do you put in the clutch of a 1988 ford ranger?
The fluid used for the hydraulic clutch is DOT 3 brake fluid
Where is the reservoir for the clutch fluid on a 1988 Honda Accord?
the clutch is setup to a mechanical clutch cable line. there is no reservoir.
Where to add clutch fluid in 1988 F 250?
The fluid for the clutch comes from the brake fluid. After the brake master cylinder, there is a clutch master cylinder which takes fluid from the brakes. Fill up the Brake master cylinder.
How do you add clutch fluid to a 1988 Nissan Pulsar?
Look near the brake master cylinder for a reservoir or your brake fluid and clutch fluid might share the same reservoir
What type of clutch fluid is required for a 1988 Chevy half ton truck?
Dot 3 brake fluid is just fine and safe.
Do you have to shift a 1988 Yamaha 350 warrior with the clutch or do you shift on the go?
no you have to use the clutch if not it will take a toll on the clutches I have owned a warrior for over 5 years and never changed the clutches in it and I shift on the go. Mine won't let me shift in a higher gear if I don't have the RPM's. Maybe I am lucky, or maybe if the RPM's are high enough it won't hurt them.
What do you use for clutch fluid for a 1988 Nissan pick up?
You can use any brake fluid that meets DOT3 rating.This rating is shown on all contain3 or a higher rating will work. A good rule to go by, is to use same fluid in clutch that you use in the brake system
Where do you put the clutch fluid in for a 1988 ford ranger What does the reservoir look like?
Should be on firewall next to master cylinder
What causes a 1988 Chevy s-10 with a manual 5 speed to shift hard?
It could be filled with the wrong oil or the clutch is failing.
How does one tell if the clutch master cylinder is bad in a 1988 Nissan D21?
Look for leaking fluid at the slave or master cylinder.
Why would the clutch not retract after you push it in on a 1988 Mazda B2000?
There is air in the clutch hydraulic system. This can be because the Master or Slave is bad, low fluid level, or it was not completely bled after installing a Slave or Master. Usually this problem is caused by a bad clutch slave which has leaked out all of the fluid. Kyrasis6 Owner of Mazdatruckin.com
