0
Why does the gear selector light stay on with the ignition off?
Wiki User
∙ 12y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
1989 ford bronco 2-do you have to be in park to go into 4x4-and will the light stay on as long you are in 4 wheel drive?
Your selector should be in the neutral position. Select 4WD H, and move selector into drive. Your light should stay on. If the light is turning off, you may have a problem with the actuator or hubs. Sometimes going from Park to Drive, your 4WD will disengage.
Why does the parking light stay on when you turn the car off?
because the lights are not controlled by the ignition switch; they are controlled by a separate light switch.
Why does your 95 Mazda protege oil and battery light stay on with no key in or ignition on.cranks over but qont start. no power to anything else?
Bad ignition switch?
Why does the security light stay blinking on your 2004 keyless entry Camry Toyota after you turn off the car?
The security light flashes when a programed key is not installed in the ignition, when you insert a programed immobilizer key in the ignition the security light will go out, the light flashes as a theft deterrent
How do you check your check engine light on your 94 accord?
Turn on the ignition and look at the dash. The light will come on and stay on for a few seconds to let you know it is working.
Why does your battery light stay on even when the keys are not in the ignition it also gets brighter when revving the engine?
Could be an alternator issue.
How do you make the headlights on a 1999 Mercedes C230 stay on all the time so they automatically turn on and off with ignition?
Set your light switch to "auto" on the dash and your lights will come on automatically with the ignition. Turn your light switch on your dashboard to "auto" or "automatic" and the lights will come on and off with your ignition switch.
How do you turn off the maintenance required light on a 2007 Camry?
Turn igniton to on position and put odometer in trip mode, turn off ignition. Hold trip button in and hold it in as you turn ignition to on position, it will flash Turn off ignition. Maintenance light should go and stay off
Why do your Jeeps high beams stay on all the time?
your beam selector lever is prob. busted and needs 2 be replaced. or its a wiring prob. check some fuses and the wires to the selector if everything is ok there, then you prob need a new selector
What if the blower and power windows only work as you start your safari van not before and not after is this a starter switch issue also if does not shift t0 2nd gear?
i have found this problem to be caused by the ignition switch that is mounted on top of the stering colum under the dash. if you have ABS, the ABS light will stay on and the trans will not shift.
Why would the airbag light stay on and the air cond windows and turn signals not work?
This was already answered for me in another post. It was the ignition switch.
Why would the battery light stay on after the ignition is turned off on a 1986 Nissan pickup?
The voltage reg is sticking and will run down the battery.
