0
Why does the hydraulic feed line keep popping out of the transmission on a 96 ford ranger?
Wiki User
∙ 9y ago
You need to replace the quick disconnect. Special tools are required to separate the joint without doing damage. Those lines are transmission cooling lines that bring the ATF to and from the cooler.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Which wire is the memory feed wire on a 1998 Ford Ranger XLT?
green one
How much pressure take in hydraulic system?
Hydraulic systems are either gravity feed systems or pressurized systems. In a gravity feed system the pressure is produced as a result of an elevated tank holding the motive fluid, returns are pumped back to the tank from a collector tank at the bottom of the system. In a pressurized system a hydraulic positive displacement pump pumps the fluid into the system pressurizing it. Relief valves will dump excess pressure back to the holding tank.
What is pressure shaft?
Pressure Shaft is enclosed pipe/channel used to deliver/feed water to hydraulic turbines in respect of hydro power plant.
What is difference between feeder and grid?
In an electrical power transmission system: the grid is what the feeder feed into.
Where do you add transmission fluid - Volvo 760?
Just pull out the dipstick, feed the tall, narrow transmission fluid funnel into the dipstick tube and top up as required.
Which Transmission Cooler line is the in on a ford c6?
Front ¼" Pipe Cooler feed/out Rear ¼" Pipe Return/in
What is apron constant?
apron constant is inverse of transmission ratio of the feed rod pinion of apron box
How does the twin engine on the helicopter work?
Both engines feed into one transmission and that mounts the main rotor.
In My Sims Ds How do you get a flower for the animal feed for Foster the ranger?
Go to Ashley at the Flower Shop and Buy the Flower Seeds Good Luck!
Where is the transmission computer located in a 1993 Honda Accord LX?
Under the passenger side floor board, up against the fire wall. Pull the carpet back and you will see it. The Automatic Transmission Control Unit is right next to the Engine Control Unit.Two bundles of wires feed up to it, three bundles of wires feed the ECU from the transmission tunnel.
Is there a 14 inch hydraulic slabbing saw?
Assuming you're after a slab saw for lapidary purposes, rather than say demolition, in my experience hydraulic feed systems are usually reserved for machines with larger blades, eg: 18" or more. The feed system for smaller saws, if they even have one, are powered by gravity or a small electric motor. DIY feeds are easy to rig up if you're sick of waiting for the beast to gnaw through tough agates. I'd suggest contacting the major manufacturers for specific details on hydraulic feeds.
What is feeder wire?
The feed line is the cable or other transmission line that connects the antenna with the radio transmitter or receiver
