I had a similar problem and it fixed itself. I think the internal mechanism was out of alignment because the light would be on when I had the seatbelt buckled and would go off when I took it off. You can try pulling the belt all the way out and letting it wind back in a few times to see if that helps. But again it may just fix itself. Hope this helps.
nissan designed the seatbelt warning light to flash i think around 7 times. there is also a warning bell with the light, however the bell deactivates once the drivers seatbelt is locked in, where as the light continues the full cycle. Naaman
You can turn off the 2009 Toyota Camry seatbelt warning light by engaging the seatbelt. You can also remove the seatbelt warning light fuse. Removing the seatbelt warning light fuse is not recommended.
Warning lights are important to pay attention to and know warning lights. If seat belt lights flash, and an air bag light flash, it means there are problems with both parts.
You can turn off the seatbelt warning light in your 2006 Ford Explorer, by buckling the seatbelts. When the seat is occupied the warning light will stay on until the seatbelt is buckled.
I had a similar problem and it fixed itself. I think the internal mechanism was out of alignment because the light would be on when I had the seatbelt buckled and would go off when I took it off. You can try pulling the belt all the way out and letting it wind back in a few times to see if that helps. But again it may just fix itself. Hope this helps.
The light warns you that you are not wearing your seatbelt. Pushing the button cancels the warning.
yes, you get a warning light on your dashboard alerting you when it is off, and does not go off when your seatbelt is on, so yes it can.
You put your seatbelt on.
Hi have the same issue sometimes, im looking to see if VAG-K-CAN interfaces will do the trick
person with seatbelt and a circle in front That is the airbag system warning light.
Check in your owners manual under the seatbelt section. I have a few years older escape and the process was relatively straight forward. Apply parking brake, turn on battery of car (not engine), wait for the seatbelt light to turn off. Buckle and unbuckle seatbelt 9 times finishing on the umbuckle position. Wait for seatbelt light to flash and stop, and buckle and unbuckle one more time. The seatbelt light will flash rapidly for a few seconds to confirm it's turned off.
Well if you are not wearing your seatbelt it will flash. See the car seat is specially designed to be able to sense when weight is on it. So if it feels pressure and knows that whoever is sitting there is not wearing the seatbelt it will flash to let you know to put it on. Its a safety devoce.