answersLogoWhite

0


Best Answer

If it has an automatic trans your neutral safety switch (located near the fire wall on the steering colum) may need adjustment.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does the starter on a 98 astro engage with the key in the acc position the starter keeps running while the van is in park. shift to neutral and the starter stops?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the neutral safety switch located on a 97 Honda Civic Coupe HX with a Manual Transmission?

Under shifter boot or housing. It detects position of shifter so you can only engage starter in neutral.


Can a bad neutral safety switch on a 1999 Jeep Cherokee prevent it from starting?

The neutral safety switch keeps the starter from engaging when the transmission is in any gear EXCEPT park or neutral. A faulty switch would either allow the starter to engage any time or not allow the starter to engage at any time.


E150 will not crank and starter does not engage?

Flat battery, neutral safety switch, starter realy poor battery connections.


What is the neutral safety switch for on a 1997 Monte Carlo?

It keeps the car from starting in gear. The starter will only engage in park or neutral.


What is the function of a neutral safety switch on a 1996 Nissan sentra?

This switch is designed to be sure that the car won't be moved by the starter motor. It requires that the car be in neutral, park, or have the clutch depressed before the starter motor will engage.


Are Jehovah's Witnesses allowed to engage in social protests such as labor related demonstrations?

Jehovah's Witnesses will maintain a neutral position with regard to these. As such, we will not engage in them, nor will we interfere with them.


What you've got is a 1984 Chevy pickup and have power to everything even the lights work fine but it will not crank What should you be checking?

Start with a volt meter at the starter. Check to verify that voltage comes in on the BIG wire, and if that's working verify that you're getting voltage to the solenoid when someone tries to engage the starter. If you have voltage to the solenoid when the keyswitch is in the "start" position, and the starter doesn't engage... it's the starter. If you're NOT getting voltage to the solenoid, check the keyswitch, wiring and the neutral lockout switch.


1980 Mercedes 300SD New starter old starter won't engage after preglow warmup on and the battery starter and celenoid connections are OK What next?

wiggle the shift lever, or try it in neutral, might be the safety switch on tranny


91 Stealth starter does not engage in hot weather unless repeat on off of switch normally when cool temps it is ok?

Loose or corroded battery cables? Bad starter solenoid? Bad starter? Weak neutral safety switch?


Starter clicks will not engage?

Seized engine? Weak or dead battery? Loose or corroded battery cables? Flat spot on starter motor? Bad starter solenoid? Bad neutral or clutch safety switch? Bad ignition switch?


Why wont the engine crank over on a 1994 Chevrolet s-10?

That's insufficient information. In general, "crank over" means that the starter is not turning the engine when you put the keyswitch to the "start" position. The starter can fail to engage because of a failed starter, solenoid, keyswitch, neutral lockout switch, faulty battery, failed alternator or just about anything that would drain the battery.


What is the name of a little sensor that sits on top of the starter?

if it bolts on the starter assembly you are probably talking about the starter solenoid. basically its what makes the starter engage. if its a sensor that just bolts near the starter it could be anything from a crank position sensor to a knock sensor.