0
Because the voltage is high?
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What should the volt meter gauge read in a 1993 jeep yj?
what should the volt meter guage read in my '93 Jeep Wrangler 13.5 to 14.2?
Why do your battery gauge read too high?
Voltage Regulator bad
Which gauge wire is a 12v?
The gauge of wire that is 12 volt is 18, 14, and 16.
Can you use the original gauges on a 1950 GMC truck when you convert to 12V how do you go about it?
Yes and no you have to rebuild the gauges so they read 12 volt The volt meter wont work with an alternator it was designed for a generator The fuel gauge is different ohms if you stay with the 6 cylinder engine the oil and temp gauge will work but if not the temp gauge has to have a longer tube installed and the oil gauge has to have different fittings installed. on the upside though your speedometer should still work.
What gauge wire for 240 volt 30 amp 55 ft?
10 gauge will work fine.
Can you use 12 gauge wire with 600 volt capacity to hook up an 300 amp 220 volt dryer?
I wouldn't, always safer to go heaver gauge. I recommend 8 gauge if you are going to be running any length of wire. Fire is never fun I believe the above answer assumes the question was meant to read, "30 amp 220 volt dryer." 12 gauge wire WILL NOT carry 30 amps safely. You need to run #10 copper minimum. It is never a bad idea to upsize, such as the recommended #8, but it is not necessary if 30 amps is what you need.
How can you check a 1995 fuel injection system?
The pressure is checked with a gauge, the electronics are checked with an appropriate scan tool and a volt/ohm meter.The pressure is checked with a gauge, the electronics are checked with an appropriate scan tool and a volt/ohm meter.
What size wire for an 80 amp 220 volt circuit?
# 3 gauge
Why would the temperature gauge read cold when the antifreeze is low?
The temperature sender (the sensor that sends the temperature signal to the gauge) has to be immersed in coolant in order to correctly read the temperature. If the coolant is so low that it leaves the sender high and dry, the temperature shown on the gauge will not be a true reading. if the sensor is not immersed in the coolant, there a big chance it wont read at all...
Why does my Ac manifold gauge read retard?
The low side gauge more than likely says retard because you hooked the low side up on the high side port
We have a gauge on our race car that requires 12 volts of power.Our cars battery is a 16 volt battery. Do we need to step down the voltage going to the gauge so it does not burn out?
Are you SURE your car is 16 volt?? I've seen 6 volt systems and 99.9% of the cars are 12 volt. So double check you numbers. I have NEVER seen a 16V battery in a car.
How do you install a autometer gauge in a Mazda 626?
It really depends which sort of GAUGE you have. For example; you couldn't wire a volt meter to the oil pressure switch.
