answersLogoWhite

0


Best Answer
Copy

The engine valve stem seals are worn. Usually valve stem seal replacement is all that is needed, occasionally there is wear in the valve stems and/or valve guides which requires further repair.

User Avatar

Wiki User

โˆ™ 2004-07-06 12:46:20
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: Why does your 1987 Corvette puff blue smoke when you first start it?
Write your answer...
Submit

Related Questions

How do you replace the gas tank Corvette 1987?

how to replace gas tank 1987 corvette


What is normal oil pressure for 1987 Corvette?

what is the normal oil pressure on a 1987 corvette when standing still


Where is the option list on a 1987 Corvette?

== == The option list on a 1987 Corvette is on a label stuck to the underside of the console cover.


Why won't my 1987 Corvette start after i have ran it but then when i let it cool down it would start?

A friend had the same problem with his 87 Corvette . His was the chip in the ignition key . Had to replace ignition switch and key , about 40 dollars for the parts .


How do you change a battery in a 1987 Corvette?

== ==


Where is the spare tire for a 1987 Corvette and the jack.?

Where is the spare tire located on a 1987 Corvette? Under the back of the car below the CORVETTE, use the lug wrench to lower it the jack is on top of the tire.


How much horsepower does a 1987 Corvette have?

240HP


How jump start battery in 1987 Corvette?

Connect the positive cable to the positive battery post on the donor car and on the Corvette. Connect the negative cable to some metal part of each vehicle, such as the engine. Be careful of the fan blades on each car. Let the donor car run for approximately 15 minutes to put a slight charge in the battery on the Corvette before you attempt to start it. Start the Corvette and as soon as it starts disconnect the battery cables.


Ignition timing for 1987 Chevy Corvette?

6


How do you change the hazard flasher on 1987 corvette Where is it located?

== ==


How many horsepower does a 1987 Corvette have?

240 HP


Do you have to remove the seats to replace the console on a 1987 Corvette?

no


Does 1986 and 1987 corvette have passenger side airbag?

No


What are the release dates for Motorweek - 1987 Corvette ZR1 - 28.27?

Motorweek - 1987 Corvette ZR1 - 28.27 was released on: USA: 6 March 2009


What are the release dates for Motorweek - 1987 Chevrolet Corvette - 27.29?

Motorweek - 1987 Chevrolet Corvette - 27.29 was released on: USA: 21 March 2008


Where is the ignition module located on a 1987 corvette?

Inside the distributor.


How can you disable the security system on a 1987 corvette?

Break it with a hammer!


What is the correct oil pressure for a 1987 corvette?

The 1987 Chevrolet Corvette oil pressure should be between 45 PSI and 40 PSI. The idling oil pressure will be slightly less.


Where is the fuel pump fuse on 1987 corvette?

The 1987 Chevy Corvette fuel pump fuse can be found in the fuse box. The fuel pump fuse will be in the second column, third from the top.


What are the release dates for Motorweek - 1987 Corvette ZR1 28-27?

Motorweek - 1987 Corvette ZR1 28-27 was released on: USA: 6 March 2009


What are the release dates for Motorweek - 1987 Chevrolet Corvette 27-29?

Motorweek - 1987 Chevrolet Corvette 27-29 was released on: USA: 21 March 2008


What is the average price for a 1987 Chevy Corvette engine?

The average price for a 198 Chevy Corvette Engine is between $27,999 and $47,998.


How do you determine if the instrument cluster is causing a drain on the battery in a 1987 corvette?

== ==


What is an ip harness on a 1987 Corvette?

instrument panel,or guage cluster


Where is the theft deterrent controller on a 1987 corvette?

Under passenger seat