Most usual reason is the ignition module in the distributor, or it could be the float needle sticking if it is the carby model.
My 94 laser has an anchor near the latch for the hatch
fuze box picture
Probably NOT
Drive it down a hill.
On all the lasers iv'e worked on, you have to top the gearbox level up by removing the speedo out of the gearbox. There is one bolt that holds the speedo in, You will need a 10mm socket to undo it. pull the speedo out. I usually use a screwdriver to pry up on it. The level should be filled up approx. half way up the gear. It's a stupid way of doing it. But that's how you do it. It's weird though cos most laser gearboxs use automatic transmission fliud.
The same way you find any shiny pokemon, either constantly run back and forth in grass that you want to encounter as a shiny, or constantly breed the pokemon until you hatch a shiny.
ninety dollars City Dismantlers
When you enter the museum at night through the underground hatch, you can hide behind them to avoid the security system's red laser beams.
Just disconnect the negative cable from the battery.
If its a hatch, slightly lift the front of the back seats and then move forward. It's under the plate in the middle.
Well, I've got a 1991 kf laser sedan, and my Jack is in the boot/trunk on the right under the corner of carpet is a wood hatch door and in the little compartment is the jack and a small tool set.
It takes three weeks or 21 days to hatch a fertilized chicken egg. Temperature and humidity must be maintained constantly. Two weeks is not long enough and incubation cannot be hurried.