check location of gas line, heat may be causeing vapor lock,
fuelpump going bad,
This is called a "hot restart problem" and is commonly caused by vapor lock, which is the accumulation of air bubbles around the main jet, emulsion tube, etc. Most immediate solution is cleaning and rebuilding of the carburetor, particularly the bowl vent and main air bleed. An alternative would be to lean out the mixture via the needle valve, if equipped.
Change gas, clean spark plug, clean carburetor if needed and adjust it.
To restart a Jaguar after running out of gas, turn the key on and off a few times. Turning the key on will signal the fuel pump to pump gas into the carburetor.
If its a new mower take it back to where you bought for warranty If you mess with it you will forfeit your warranty.
The float valve is probably stuck open.
If you are talking about the bulb button it is a primer to get gas to the carburetor if the mower has not run for awhile. Usually not needed to restart a warm mower.
Your Bendix is sticking on your starter!! get it rebuilt! it is not disengaging or engaging due to the heat!
Im guessing this is a petrol lawnmower. sounds like the float is not set at the correct level in the carburetor
It is possibly the gas pump became damaged...ortry dropping some gas in the carburetor directly, then try to start it againAlso replace the fuel filter.
The next thing to check is to see if it's getting fuel. Crank it a few times, then take out the spark plug and see if it's wet. If it isn't, it isn't getting fuel.
to restart a PSP you have to.... attach it to your computer... then delete the files or restart it from there
widget restart bu ten using the my computer restart agent restart