could be a vacuum leak. check all your hoses for cracks going to the carburetor. also pinch off the big hose going to your vaccuum brake booster with a vise grip. could be your booster has a ruptured diaphram. if it doesn't seem like a fuel/vacuum problem, it may be a shorted wire in your steering column. is your car column shift?
Put the car in drive, unbuckle, and floor the gas pedal. The lights will turn on as needed.
car turn off when put in to drive i hit the gas an it starts shacking an turns off why?
As long as the bolt pattern is the same and the spacing is the same (4.75") you can swap rims. If you have 14" steel rims you can put 15 or 16" Aluminum rims on but do all 4 other wise the speedo will be off. Also front wheel drive wheels are not the same as rear wheel drive. So put the right ones on.
No but, be sure it has come to a complete stop before you put it in park.
You put the hand break on, turn the traction control off and avs, then, finaly find a switch called 4x4 and click it.
It is best for the vehicle if you are at a complete stop, put the trailblazer in neutrail, turn the selection knob to your right to whichever setting you would like, wait for it to engage, then put it in drive and take off!
well you can do you turn the car off after or do you just do it at stop lights? If you put it in neutral at stop lights and signes and then put in gear to drive it add wear to your transmision. Just leave it in drive when driveing.
Turn 4WD off. Put transmission in reverse and back up a few feet. Return transmission to drive. If this does not work then something is not right and you should probably take it to a shop. Turn 4WD off. Put transmission in reverse and back up a few feet. Return transmission to drive. If this does not work then something is not right and you should probably take it to a shop.
turn it off
put the car in drive and crankshaft wont turn anymore. then you can take off the bolt
You can't turn a Tamagotchi off. You can put it on pause though.
over-drive... take it its an auto On the gear selector handle, there is a button. Pushing that button will turn the Over drive off (light is on) or turn it on (light is off). This allows it to leave 3rd gear, and will put less wear on the engine and transmission at a speed of about 45 or higher.