alternator is bad
Begin by removing the positive cable from your battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new Pontiac Montana battery.
To replace the 2002 Pontiac Montana battery disconnect both the battery cables from the terminals. Then, remove the screw to the battery holder, located behind the battery. Slide the battery slightly to the front of the vehicle and lift up. Reverse this procedure to put in a new battery.
The proper way to use jumper cables to boost a low/dead battery: (1) one end of positive jumper cable to "dead" battery; (2) opposite end of positive jumper cable to "good" battery; (3) one end of negative jumper cable to "good" battery; (4) opposite end of negative jumper cable to GROUND on "dead" vehicle. Remove jumper cables in reverse order.
To bypass the window switch on a 1999 Pontiac Montana, you can use a jumper wire to connect the window motor directly to the power source. First, remove the door panel to access the window motor and locate the motor's power wires. Then, carefully connect the jumper wire to the appropriate terminals on the motor, allowing you to raise or lower the window manually. Exercise caution to avoid short circuits or damaging the motor.
cant open tailgate
you must remove the front suspention crossmember and suspension.
I cannot find how to remove the cup holder from the dash of my 2001 Pontiac Montana
pull it really hard
Remove the 2006 Pontiac Montana wheel and tire. Remove the brake pad Springs. The brake pads will come off. Reverse the process to install the new brake pads.
Best and easiest way to change battery in any Volkswagen. Remember if your computer loses power it will go into limp mode and you will find yourself at the dealership for vag-com. Have a friend with a good battery and a set up jumper cables and hook cables from his battery to yours, loosen battery terminals on your battery and carefully remove battery with out knocking the cables off (remember keep power to the battery cables on your WW). Carefully install your new battery and tighten the terminals. With jumper cables still hooked to your car start your engine, then remove the jumper cables. I would then take car for a short drive to ensure that there is a full charge to the battery you just installed.
It is hard but just go to autozone.com and they have an OK instruction for this!
dynamite