Sometimes the torquconverter can fail causing the engin to stall. In reverse it lock in full torqu. In fwd gears it slips. This is only one idea.
clutch
It sounds like you need a new clutch! I have an automatic Transmission just recently installed .
The car began to stall, so he brought it to a mechanic.He had a stall selling hats and scarves at the market.The car began to stall, so he brought it to a mechanic.He had a stall selling hats and scarves at the market.The car began to stall, so he brought it to a mechanic.He had a stall selling hats and scarves at the market.The car began to stall, so he brought it to a mechanic.He had a stall selling hats and scarves at the market.The car began to stall, so he brought it to a mechanic.He had a stall selling hats and scarves at the market.The car began to stall, so he brought it to a mechanic.He had a stall selling hats and scarves at the market.The car began to stall, so he brought it to a mechanic.He had a stall selling hats and scarves at the market.The car began to stall, so he brought it to a mechanic.He had a stall selling hats and scarves at the market.The car began to stall, so he brought it to a mechanic.He had a stall selling hats and scarves at the market.The car began to stall, so he brought it to a mechanic.He had a stall selling hats and scarves at the market.The car began to stall, so he brought it to a mechanic.He had a stall selling hats and scarves at the market.
because if you stop immediately then the car will stall.
Try to start car,it will stall out. Leave the key on for 10 mins. until the light stays solid. Turn the key off. Start the car.
if you have a cracked distributor cap then water would get inside it and make your car stall.
Yes, the signal to the PCM can be wrongfully perceived as low coolant, even if the car is full of anti-freeze.
There are a few reasons why a car might stall when cold. The car might just be stiff from the cold weather.
yes a bad converter will make car stall
If the car is starving for fuel or air (low power at idle), the car will stall while turning.
A bad water pump can cause your car to stall if the bearing has failed or it is causing overheating. A seized bearing will put excessive strain on the engine and stall it out.