yes a bad converter will make car stall
It could be an issue with the torque converter.
If you're talking about a TH400 transmission, yes... the TH350 torque converter is one inch smaller in diameter than the TH400 torque converter (12" vs 13"), and you'll have to make sure the holes on the flexplate line up (or drill them for both patterns). You'll get a bit more stall out of the 350 converter. If you're talking about the 700R4, the answer is going to be no.... that uses a lockup converter, which will not interchange with the TH converter.
it may be a bad torque converter.
Yes, loose converter bolts sound a lot like a failed rod bearing.
thae catalitic converter is pluuged
Put tranny up then install the torque converter to tranny first , NOTE : Make sure when installing the torque converter to the tranny that you can only slide your middle finger in bettween the tranny and torque converter , if the torque converter is not all the way in, the torque converter will tare up the tranny shaft.
Sounds like torque converter is going bad
Bad torque converter. They lock when you go at highway speeds, to improve efficency. If they don't disengage properly, the car will stall when you stop. Could be a bad solenoid (switch). Can be fixed or bypassed. If bypassed, you save the cost of a repair, but will lose highway efficency.
sounds like the torque converter is locking up, bring it to a transmission shop.
a bad torque converter can sometimes make the vehicle die while stopped.[there are ohter less expensive reasons ]
the clutches in torque converter
If the torque converter is loose it can do alot of damage to the transmission too. My ex- had to replace the transmission because the bolts were not put in correctly when someone else had changed something out. He had to put in a new transmission and torque converter. If it is running too rough you may have to change it all out. Check the bolts first to make sure everything is tight. If it is then you'll probably need new trany and torque converter.