answersLogoWhite

0


Best Answer

why does my headlight fuse 10amp factory fieted from Renault to burn out perhaps the relye

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why does your headlight fuse 10 amp factory fieted to burn out wotcose?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why the headlights break on a 1992 dodge spirit changed a headlight 10 minutes later the same headlight burn again?

your headlight is probably full of water


Would a bad headlight switch make one of the headlight bulbs to burn outalways on the driver side?

No! The headlight adjustment is out of whack or you did a hit and run that you forgot about that bent some things holding the headlight.


When did Ole Kirk's factory burn up?

in 1920


How many calories burn in factory work?

14


What causes Chrysler 2000 jxi to burn out headlights frequently?

Your headlight is leaking, allowing water to enter the lens. when it is on water will burn out the bulb.


Where is the Low beam fuse for Nissan Xterra?

There isn't one. The low beam of the headlight will burn out if it is not working.


Is it OK to replace a headlight bulb when the headlight cover is broken?

Sure you can replace it! It will just burn out at an accellerated rate because of dirt, oil, and moisture making it's way into the housing.


Do CD duplicators typically press or "burn" discs?

CD duplicators always burn discs. Pressing discs only occurs in a factory setting.


Will it burn the wires if you remove the spark plug heat shield?

The factory puts the shield there for a reason.


Can you put AC to a 1977 Yamaha enduro 100 head light?

Yes, but not more than 13 - 15 volts, or the headlight filament will burn out.


How do you replace a 1997 pathfinder headlight?

behind the headlight is the bulb socket, (wires go into it) grasp it and turn with your fingers. about 1/4 turn, pull back, should pop right out. do not touch new bulb with your bare fingers, as these bulbs will burn out quickly if you do.


How do you change the headlight bulb on an Acura Vigor?

Open the hood. look at the rear of the headlight housing. Rotate the bulb holder counterclockwise and pull the bulb out. Disconnect the plug from the bulb. Wipe the new bulb with a clean cloth if it is dirty, or you get your fingerprints on it, or it might burn out.