0
It turns on just fine, just doesn't shift into gear. Transmission Fluid is full.
What else can I help you with?
1994 Ford Probe squeals when started?
I Have 94 Probe 4 cylinder that squealed when I started it. the pully on the water pump was lose
Y does everything you read about your 1994 probe gt say it has a 2.5l engineit has a 3.0is this not the original engine?
The 2.5l 6 cylinder engine is the original engine in a 1994 ford probe gt and in the se and base it is a 2.0l 4 cylinder engine
How do you install a timing belt tensioner in a 1994 ford probe 2 cylinder?
just replace the engine with a 4 or 6 cylinder and your done.
What do you gap spark plugs for a 4 cylinder 1994 ford probe?
.044 inch according to fordparts.com
How do you change the clutch master cylinder in a 1994 ford probe gt?
im sure this is on the clutch pedal itself.
Where is the thermostat located on a 1994 Ford Probe GT?
The thermostat is located on the right side of the engine looking in, in between the intake manifold and the air filter box, underneath the wiring. This is in a 1994 Ford Probe GT 6 cylinder
If your 1994 Probe 4 cylinder will not idle what do you need to do?
Hey Bill==It is probably the idle speed solonoid. Have it checked out. GoodluckJOe
Where is the place for the starter in ford probe 1994 SE 4-cylinder and where do you hit it to make it work?
Lower rear end of the engine passenger side
Will a 1995 Ford Probe transmission fit in a 1994 Ford Probe?
yes....
What type coolant for 1994 probe?
Water
Will a sunroof from a 1995 Ford Probe GT fit into a 1994 Ford Probe SE?
Yessir, it will.
Where is park neutral safety switch located on a 1994 ford probe gt and how do you replace it?
On a 1994 Ford Probe GT, the neutral safety switch is located on the transmission near the shift linkage. To replace it, first disconnect the battery, then remove the shift cable and any electrical connectors attached to the switch. Unbolt the old switch from the transmission and install the new switch in reverse order, ensuring it is properly aligned with the shift linkage before securing it. Finally, reconnect the battery and test the switch by shifting through the gears to ensure it functions correctly.
