depending on the vehicle, some seat belt alarms can be disabled theu settings in the vehicle,check owneres manuel for instructions how to do this or to undoe this
Seatbelts save many lives around the world each year. However, cars still remain among the most dangerous methods of transportation. Seat-belt are found in the latch mechanism. If the magnet does not sense the belt connected it will alarm you with a noise and a sign on the dashboard.
Yeas it will
The seat belt has to be ingaged for heater to work. The seatbelt has to be ingaged to work
there are seat belt extenders that might work
alarm doesnt wrk neither does door locks with key
yes it will cause it doesnt use the signal to set the alarm or time.
Yes.
You can't. Its part of the computer. Maybe the dealer can? The work around my boss uses is plugging in a seatbelt extension which is around $25-$50 from a dealer
here you go try going here first www.ebookspdf.com/automotives/3189/ford-escape-2001-owners-manual/and if that doesnt work try what i did get in like ur going somewhere without ur seat belt on put ur key in to the on position but dont turn it on wait till the seat belt light goes off then pull ur seat belt in and out 3 times then real fast turn ur light on then off then real fast pull ur seat belt in and out again 3 times then in 5 sec. pull it back in and out then the seat belt light should flash 4 times or so if u done it right hope this help.
when it doesnt work
no if you have the type of seat belt that you can keep pulling. They only work at higher speeds.
I can assume that you are talkin about centre belt cause they seem to be a big problem. First of all before you go there , there is a cable that runs from the seat belt unit to the catch that your seat clips into when you have laid it down. You will probably find that the seat catch is not engaged properly which stops a cable from retracting and allowing the seat belt mechanism to release. Try lubricating the latch at the rear of the seat and also slamming. This is a safety device so if your seat is not clipped in properly you cannot pull out seat belt. If this doesn't work - Unclip the the rear protector on the rear of your seat and you will see along the edge of the seat near the bottom ,where you undo the fabric from the seat . Fold the fabric at the top away after unclipping the plastic insert were the belt goes into the seat, You will see some screws holding a steel plate over the belt. Remove the plate - Look on the back of the seat on the steel part and there is a bolt holding seat belt in place , Undo this and abstract seat belt from between foam and release cable from seat belt..