0
Why doesn't your starter kick on when you turn the ignition switch in your 1997 Nissan 200SX SE-R?
Wiki User
∙ 12y ago
I can think of 5 things, if battery is charged,
1. Ignition switch has went bad or out of ajustment.2. Manuel trans- Clutch safety switch bad or out of adj. ( should be under dash.3. Auto trans. Neutral safety switch bad out of adj. 4. Starter bad5. If has one, starter relay bad
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How to Remove ignition switch from Nissan?
how to change a ignition switch on a nissan altima 2003
2005 Nissan altima key wont turn ignition switch?
It seems that there could be a problem with your starter. It happened to me too.
How do you remove a damaged ignition switch in a 1995 Nissan Quest?
how do i remove the ignition switch in a 1995 Nissan quest
After a new battery and starter and checking fuses and bypassing the clutch safety switch why would a 1993 Nissan King-Cab still not start?
Loose or corroded battery cable? Bad starter solenoid? Ignition switch?
How do you change ignition coil in Nissan sentra 2001?
How change my ignition switch nissan 2001 sentra.
I have to turn the ignition key several times before it will start. I doesnt do it every time. The battery is ok. Any ideas?
Ignition switch going bad, corroded or loose battery cables, starter relay or starter going bad.
Is there a starter swith on s10 95 chev?
You have a starter/ignition switch mounted in the steering column and you have a starter solenoid switch that is mounted to the starter.
Where is the reverse solenoid switch located on a 1997 Nissan Maximum?
The 1997 Nissan Maxima. Reverse solenoid switch is located on the starter. The solenoid switch is attached to the side of the starter.
How do you remove ignition switch on 1996 Chevrolet Tahoe?
Chevy Tahoe Ignition Key Starter Switch
How about if it doesnt make any noise when you try to started but the batterie is find?
No noise when you try to start the vehicle usually indicates a dead battery, or a loose or disconnected cable/wire at the starter, solenoid (starter relay switch), or ignition switch.
How do you change the ignition switch on a 93 Nissan quest?
Begin by removing the retaining ring at the top of your 1993 Nissan Quest ignition switch. Slide the ignition barrel out. Remove the wiring harness from the end of the ignition barrel. Reverse the process to install your new ignition switch.
Trying to start 96 Nissan 240sx and everything electrical comes on but car wont start have to jiggle the key or somethin then out of nowhere it'll just start Is that the starter or ignition?
The problem lies in the ignition switch - had a Nissan pick-up that did the same thing.
