0
Why dont my tail lights brake lights and signal lights work on my 2008 dodge avenger?
Wiki User
∙ 12y ago
2008 Dodge Avenger brake light/turn signal light bulb troubleshooting (check in this order):
· Check Fuses
· Check Bulbs
· Check Relay(s)
· Check Light Switch(es)
· Check license plate light bulb and wiring
· Check trailer hitch wiring harness
· Check all wiring harnesses and wire
Most likely its the fuse or a burnt bulb breaking the circuit. Sometimes the license plate and/or the trailer hitch is wired into other circuits and can cause issues in other areas. Sometimes its wires grounding out somewhere on the vehicle. See sources and related links below for bulb information. See owner's manual for location and identification of fuses as well as for bulb replacement procedures.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the turn signal flasher located on a 1999 Dodge Avenger ES?
The 1999 Dodge Avenger signal flasher relay switch is located beneath the drivers side dashboard. The signal flasher relay switch will be between the gas pedal and the brake pedal.
Will a bad signal light flasher stop the brake lights from working on a 1983 dodge d 150 pick up?
Assuming the signal lights still work, no. But a bad brake light switch or a blown brake light fuse could.
What are the lamp numbers for the tail brake and signal lights for a 1993 dodge shadow?
See sources and related links below for 1993 Dodge Shadow tail light, brake light and turn signal light bulb part numbers.
What kind of brake fluid for a 1996 Dodge Avenger?
Dot 3
If turn signal switch is bad on a 1986 dodge D100 what will happen?
when my 1986 w-250 turn signal switch went out the brake lights quit working.
What does is mean when the brake light on a 1997 dodge avenger?
The red brake light on the dash means that the brake fluid is low or the parking brake is on.
How do i turn on the interior lights of a 1999 dodge avenger?
Push the button below them.
Dodge Dakota brake lights?
dodge 2001 Dakota brake lights won't burn Check the fuses. If the fuses are okay check the brake light switch.
How do you replace the brake or turn signal bulb on a 2008 Dodge Avenger?
2008 Dodge Avenger turn signal and/or brake light bulb replacement: Purchase the correct replacement turn signal and/or brake light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal and/or brake light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Where is the Brake Shift interlock solenoid on a Dodge Avenger 2008?
It is inside the shifter assembly.
1979 Dodge B200 Sportsman V8 brake pedal makes all signal lights come on with brake lights the hazards or signals don't work on their own could it be a flasher?
On the 1979 B200 Sportsman V8 if the brake pedal makes all signal lights come on and hazards and flashers do not work on their own, it could be the flasher, but the culprit could also be a burned out bulb or a short in the wiring.
Why does the brake light stay on in a 1999 dodge stratus?
Brake lights could stay on in a 1999 Dodge Stratus because of a short in the wiring. If the headlamps are off and the brake lights are still on, check the wiring for the brake lights that is inside the trunk. Sometimes cargo in the trunk can interfere with the lights.
