answersLogoWhite

0


Best Answer

The engineers who designed the evaporator dripper were complete idiots.... around the dripper it is sealed with a foam material that gives way with time and heat. Additionally debris block water from exiting causing it to back up around the dripper through the firewall... You have to have someone seal the hole.... Get a professional that doesnt need to take apart ur whole dash to seal it. Saves a lot of time and money....

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Why is drivers side Floor board wet in 2001 Mitsubishi Eclipse?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the TCU located on a 1997 Mitsubishi eclipse?

It depends. if you have a eclipse that was made by chrystler then it is the one box deep behind the radio mounted on the floor board. it looks like an ecu but chrystler put that under the hood. If its a Mitsubishi made eclipse then the ecu is right beside the tcu behind your radio. the tcu in the Mitsubishi made car is to the right on the pasengers side.


1999 Mitsubishi eclipse where is the spare tire located?

In the trunk. Under the wooden board.


How do you remove the dash board on a 2002-2004 Mitsubishi Eclipse?

remove the screws. make sure you don


Where can you find info on installing the dash board and all electrical instruments on a 94 Mitsubishi eclipse?

car manual


Where is the fuse panel located on a 1995 Mitsubishi montero?

under the hood or under the dash board on the drivers side!


Where is Carbon canister in a 2002 Dodge Caravan?

Under the van, under the drivers floor board.


Where are fuses located on a 1989 camaro?

Right above the drivers side floor board under the dash.


What are the steps to remove a 2003 Mitsubishi Eclipse dash board?

Remove the plastic cover going around the board. It sits on clips. After you will see 4 screws holding the board. Remove them too. Pull out carefully the board, disconnect 3 wire harnesses.


On board diagnostic system What does code P0403 in a Mitsubishi Eclipse 2001 mean?

Trouble code P0403 means: EGR Control Solenoid Circuit Malfunction


Where is the pcm on 97 f350 powerstroke?

in the drivers floor board by the emergency brake pedal. It is removed from under the hood.


Where is the key-less entry module for a 1997 Nissan Pathfinder located?

underneath the drivers seat, on the floor board


How do you replace the rear engine mount on a 2001 Mitsubishi eclipse spyder gt v6 3.0L?

In order to replace the rear engine mount on a 2001 Mitsubishi Eclipse Spyder GT v6 3.0L, one would first need to acquire a few jack stands to help accommodate the steps involved. From there, the Eclipse Chat Board would need to be lifted off, and the mount can be replaced from then on.