Want this question answered?
No, separating sand from water is a physical process as the chemical identities of the sand and water remain the same.
A simple filter would be suitable for separating sand and water. An alternative would be to evaporate the water, leaving the sand behind.
it makes the sand moist
You get a mixture of salt and sand. Nothing more happens.
Water is passed through sand filters to purify the water.
By washing your hands thoroughly with germicides.
Add water and warm to dissolve the salt. Filter the whole solution to leave the sand. Rinse the sand and filter again. Evaporate the water off the salt solution.
You toss the sand and salt in a filter that will not allow the sand through, Then rinse the sand with clean water until all of the salt has been dissolved and removed from the sand, Then evaporate the water and you will have the salt separated from the sand.
Baking soda is soluble in water. Rinse the mix through a filter with water. The sand will remain in the filter while the baking soda dissolves in the water.
rinse in water
First you want to get the iron filings out. You do this with a magnet.Next, put the sand-salt mixture in water. Stir well to dissolve the salt, then pour off the water. (If you really want to be slick about it, rinse the sand in plain water.)Then put the salt water in a shallow dish and let it evaporate.
To clean a water bottle you have to put fine sand into the bottle and then pour water and put one of your fingers to plug the bottle and shake for a little while and pour the sand and water out then rinse. Make sure the sand is gone. If you don't wash the bottle at all it will get moldy. Another way is to get a very small brush, stick it inside the bottle and scrub.
The best way to sterilize it - would be to soak it overnight in a weak solution of Milton fluid (baby bottle sterilizer) - HALF a cap-full per GALLON of water. Let it drain thoroughly, then rinse it at LEAST twice in clean water. Once it's drained for the last time, spread it out on a baking tray(s) and heat it in the oven on its maximum setting for an hour. Let the sand cool, and it's ready for use.
Fresh water and approx. 2tsp of salt with 2 tbsp of cornmeal every 1/2 hour for 2-3 times. That is to rinse the sand out.
You can dissolve the sand and salt into the water. when this happens the salt will be dissolved and the sand will stay at the bottom. then get some filter paper and pour the mixture through it. the dissolved salt and water will go through leaving the sand. there you have the sand aside. to get the salt aside just boil the water until it evaporates completely and you will be left will your salt. then you have your sand and salt separated. by sifting it
No. The water is in the sand.
Iron filings removed magnetically. Water will dissolve sodium chloride and suspend sand. Sand can be filtered out of the solution, and salt reovered by evaporation of water. Naphthalene can be removed separately if necessary by solution of mixture in alcohol.