Want this question answered?
Underneath each side of the exhaust manifolds.
easy question here. have flowmaster exhaust installed and a cold air intake also a header for exhaust would be good and port and polish both exhuast and intake manifolds. also better spark plugs and high performance wires. a good do it your self would be to dremel out your throttle body and make it a sixteenth inch larger in diameter then polish it. and yes i said dremel its the easy to use tool every one can get
It is on the exhaust manifold.It is on the same part on all vehicles.The only difference is on newer models cars it may have two oxygen sensors one on the exhaust manifold and one at the catalytic convertor.You will have just ONE on the exhuast manifold.
the b2200 motor is the same basic Mazda fe short block. the only difference in the blocks is the f2, or the 2.2 is the block being the stroked version of the fe. same bore same block same mounts. different head, intake, and exhaust manifolds. also different ecu and harness.
A replacement exhaust for a Mazda RX8 can be purchased online from retailers such as Partstrain or Ebay. Additionally, a local Mazda dealership could be a valuable resource in obtaining a new exhaust system.
The 2008 Mazda MAZDA6's turning circle is 38.7 ft..
The 2006 Mazda MAZDA5's turning circle is 34.8 ft..
The 2009 Mazda MAZDA6's turning circle is 35.4 ft..
The 2012 Mazda MAZDA6's turning circle is 35.4 ft..
The 2011 Mazda Mazdaspeed3's turning circle is 36.1 ft..
The 2004 Mazda MAZDA3's turning circle is 34.1 ft..
The 2005 Mazda MAZDA3's turning circle is 34.1 ft..